• Any objects such as coins, safety pins, nails, stitute a fire hazard and should not be placed screws, stones or any other hard, sharp ma- terial can cause extensive damage and must in the tumble dryer. not be placed into the machine. www.zanussi.com...
Page 3
• This machine is not intended for use by please adjust the feet in order to allow air to young children or infirm persons without su- circulate freely under the appliance. pervision. • Children often do not recognise the hazards associated with electrical appliances. Chil- www.zanussi.com...
12 hours before connecting it to when the dryer is in use, it should be placed the electricity supply and using it for the first on a firm, level surface. time, so that the oil can flow back to the www.zanussi.com...
Page 5
13 amp ASTA approved BS 1363/A fuse must be used. 1. Open loading door 2. Pull off adhesive strips from inside ma- chine on top of drum. The wires in the mains lead are coloured in ac- cordance with the following code: www.zanussi.com...
Page 6
The switch must not break the yellow and green Read carefully the instructions supplied with earth cable at any point. the kit. Door reversal To make it easier to load or unload the laundry, the door can be reversed. The door must only www.zanussi.com...
Warning! If the appliance was not compressor. Otherwise the compressor could transported in an upright position, leave it be damaged. to stand for 12 hours before connecting it to the electricity supply and using it for the first www.zanussi.com...
For thin fabrics which are also to be ironed, SYNTHETICS 3 kg all except e.g. knitwear, cotton shirts. IRON DRY For further drying of individual items of laun- TIME 8 kg dry or for small volumes of less than 1 kg. www.zanussi.com...
Drying in the tumble dryer possible in This appliance can be used for all wet laundry principle items which are labelled as suitable for tumble- drying. www.zanussi.com...
• anti-crease phase start and end DELICATE • cycle interruption this function decreases the movement of the laun- • error dry during the cycle. The laundry after the cycle is more soft and loose. For synthetic programmes on- TIME www.zanussi.com...
If 5. Close the door. Cleaning and maintenance Emptying the water reservoir Empty the water reservoir after every drying cy- cle. Caution! The condensed water is not suitable for drinking or for preparing foodstuffs. www.zanussi.com...
Page 12
• A dirty heat pump can only be cleaned up by Use a damp cloth to wipe down the control means of a costly process. panel and housing. • As necessary, approx. once every 6 months, remove the fluff from the heat exchanger us- www.zanussi.com...
2) follow program recommendation - see Programme overview chapter 3) see Care and cleaningchapter 4) see Machine settings chapter 5) only dryers with the LCD 6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section). www.zanussi.com...
4. To memorize setting press simultaneously the the LONG ANTI- the end of the cycle. Your dryer CREASE and START/PAUSE buttons or turn knob to O off position allows you to regulate the sen- sitivity of the drying sensor based on conductivity values of the water. www.zanussi.com...
– Methods for measuring the perform- • Energy consumption (corrected with final hu- ance). midity) during the cupboard dry cotton cycle with half load. • Final humidity (during cupboard dry cotton, iron dry cotton and cupboard dry easy care) www.zanussi.com...