Table of Contents
Advertisement
Installation work and repairs to
electrical components of this
appliance must only be carried out
by a suitably qualified and
competent person in accordance
with local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
What to do if, ...
... the hob or cooking zones cannot
be switched on
Check whether
– the pans being used are suitable.
– the safety lock is activated.
If necessary, deactivate it (see
"Safety lock").
– the mains fuse has blown.
If none of the above is the case, then
disconnect the appliance from the
electricity supply for approx. 1 minute.
To do this:
– switch off at the isolator, or
– withdraw the mains fuse.
Reconnect to the mains supply and
switch the appliance on. If it still will not
start, contact a qualified electrician or
the Miele Service Department.
Problem solving guide
... an ß appears in the display for a
cooking zone
Check whether
– the zone was switched on by mistake
without a pan on it.
– the pan being used is suitable for
use on an induction zone, and that it
is large enough (see "Suitable pans").
... an F appears in the display for a
cooking zone
The temperature sensor for that
cooking zone is defective.
Do not use this zone until it has been
repaired.
Contact your nearest Service Dept.
(See back page for address).
... an individual cooking zone or the
whole hob has switched itself off
automatically
The safety switch-off feature or the
overheating protection mechanism has
been triggered (see "Safety switch-off"
and "Overheating protection").
33
Hide quick links:
Advertisement
Table of Contents
