Arm Traps; Ensuring That Ids And Auth Traps Display In Airwave - Dell PowerConnect W-Airwave Manual
W-airwave 7.5 best practices guide
Hide thumbs
Also See for PowerConnect W-Airwave:
- User manual (334 pages) ,
- Configuration manual (176 pages) ,
- Manual (50 pages)
Table of Contents
Advertisement
wlsxFrameRetryRateExceeded
wlsxFrameReceiveErrorRateExceeded
wlsxFrameFragmentationRateExceeded
wlsxFrameBandWidthRateExceeded
wlsxFrameLowSpeedRateExceeded
wlsxFrameNonUnicastRateExceeded
wlsxChannelRateAnomaly
wlsxNodeRateAnomalyAP
wlsxNodeRateAnomalySta
wlsxEAPRateAnomaly
wlsxSignalAnomaly
wlsxSequenceNumberAnomalyAP
wlsxSequenceNumberAnomalySta
wlsxApFloodAttack
wlsxInvalidMacOUIAP
wlsxInvalidMacOUISta
wlsxStaRepeatWEPIVViolation
wlsxStaWeakWEPIVViolation
wlsxStaAssociatedToUnsecureAP
wlsxStaUnAssociatedFromUnsecureAP
wlsxAPImpersonation
wlsxDisconnectStationAttackAP
wlsxDisconnectStationAttackSta
ARM Traps
AP Power Change
AP Mode Change
AP Channel Change
Ensuring That IDS And Auth Traps Display in AirWave
Validate your ArubaOS configuration by exiting the configure terminal mode and issue the following command:
(Controller-Name) # show snmp trap-list
If any of the traps in the output of this command do not appear to be enabled enter
mode and issue the following command:
(Controller-Name) (config) # snmp-server trap enable <TRAPS FROM LIST ABOVE>
(Controller-Name) (config) # write mem
NOTE: See
the ArubaOS CLI.
Ensure the source IP of the traps match the IP that AirWave utilizes to manage the controller, as shown in
11. Navigate to APs/Devices > Monitor to validate the IP address in the Device Info section.
20 | AirWave and Dell PowerConnect W-Series Integration Strategies
Appendix A, "ArubaOS and AirWave CLI Commands"
for the full command that can be copied and pasted directly into
Dell PowerConnect W-AirWave 7.5 | Best Practices Guide
configure terminal
Figure
Advertisement
Table of Contents
