Page 1
A=A=+=_c.=3=.=- Care anual mic Cooktops Models: CEF, CEP, CET...
Page 2
[f you have any questions, please contact us at 1o800o735o4328. For additional information, visit our web site at www.thermador. corn or write to us at: Thermador Customer Support Call Center...
Table of Contents _mportant Safety _nstructions ...... Setting the Controls - CEF and CET Models.8 Cooktop Mode_s ..........Using Proper Cookware ........Cooktop Controls ..........Cookware Characteristics ........To test the flatness of your pans ......Cooktop Operating _nstructions ....
Page 4
READ iNSTRUCTiONS BEFORE USING YOUR COOKTOP WARNING WARNING mFTHE INFORMATmON mNTHIS MANUAL RSNOT TO REDUCE THE RISK OF FmRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE FOLLOWED EXACTLY, A FmRE OR EXPLOSION THE FOLLOWING: MAY RESULT CAUSmNG PROPERTY DAMAGE, PERSONAL raN JURY OR DEATH.
Page 5
READ iNSTRUCTiONS BEFORE USING YOUR COOKTOP Use only dry pot holders. Moist or damp pot Use high heat settings on the cooktop only when holders on hot surfaces may cause burns from necessary. Use low to medium settings to heat oil steam.
Cooktop Models ,(:) ..L S '_,j ," < (_, :: 0EF365, 0EP365, 0ET365 CEF304, CEP304, CET304 0EP456 TYPE SIZE WATTAGE 1200 W Single 6" (140 mm) Double 750/220 5"/8"(120/210 800/1600/2300 Triple 5"/7"/8"(120/175/210 800/1600/2500 Triple 5"/7"/9"(120tl 80/230 1800 W Single 7"(180 mm) 4000 W...
Page 7
Getting to Know Your Cooktop Controls CEF304, CEP304 Single Surface Unit Touch Pad Panel Lock Pad Power Pad; Pan Size Selector Keep Warm Pad Element Heat Settings Zone Smart (not on CET) On Indicator Light 0EF365, 0EP365 4. Pan Size Selector 7.
Cooktop Operating Instructions Cooktop Operating Instructions BEFORE USENG THE COOKTOP FOR THE _NDICATOR LIGHTS FIRST TiME • Remove all packing materials and literature from the cooktop surface. • While cool, wipe with a clean, damp sponge dry. • Apply the Cooktop Cleaning Creme®...
• Touch cook setting indicator. fer the heat. • No pan has been placed on the element (CEF and CET models only or Zone Smart turned off on CEP models.) Engmish 6...
Cooktop Operating Instructions Setting the Controms oZone Smart ZONE SMART PAN SENSING AND S_Z_NG The placement of the element control corresponds the placement of the heating element on the cooktop. (CEP MODELS ONLY} On CEP models, Zone Smart win always be acti- vated when an element is turned on.
Pan Size until desired pan size is displayed. See Step 3 below. Setting the Controls - CEF and CET Models Touch desired cook setting. Touch desired heat setting. If a selection is not made within 5 seconds, Element starts heating.
Model AEGRIDDLE, is available from your local Thermador dealer. To test the flatness of your pans: Turn the pan upside down on the counter top and place a ruler flat against the bottom of the pan.
Cooktop Operating Instructions Heat Settings for Radiant and Bridge Elements All these settings are recommended without the element being preheated. A range of heat settings are listed because the actual TYPE OF FOOD HEAT SETTmNGS setting depends RADIANT * These Suggested set- ELEMENTS type and quality of pan;...
Cooktop Care and Maintenance Cleaning Guide BEFORE USE CARE DAILY CLEANING TECHNIQUES Care is easy when preventative steps are taken. For 1. Clean the surface when it is completely cool with example, apply a small amount of Cooktop Cleaning the following exception.
Page 15
Cooktop Care and Maintenance Special Care Chart POSSIBLE SOLUTION TYPES OF SO_L Dry sugar, sugar syrup, milk or tomato spills. Faimure to remove these soils immedLateLy Melted plastic film or foil. All these items Permanentmy damage the surface. REQUIRE _MMED_ATE REMOVAL.
Page 16
Element turned on without a pan in place. (CEF and CET Models or CEP with Zone Smart turned off.) A slight odor is noticeable when an element It is normal and will disappear...
Page 17
Should the appli- date. Thermador will pay for all repair, labor, and ance be sold by the original purchaser during the war- replacement parts found to be defective...
Page 18
For the most detailed information, refer to installations instructions accompanying product or write Thermador indicating model number. We reserve the right to change specifications or design without notice. Some models are certified for use in Canada.