Configuring Storm Suppression; Setting The Statistics Polling Interval - HP 6125G Configuration Manual
Layer 2 - lan switching
Hide thumbs
Also See for 6125G:
- Command reference manual (426 pages) ,
- Configuration manual (379 pages) ,
- Release note (60 pages)
Table of Contents
Advertisement
Configuring storm suppression
In interface view, you can set the maximum size of broadcast, multicast, or unknown unicast traffic
allowed to pass through an interface. When the broadcast, multicast, or unknown unicast traffic on the
interface exceeds this threshold, the system discards packets until the traffic drops below this threshold.
The storm suppression thresholds configured for an Ethernet interface might become invalid if you enable
the storm control function for the interface. For information about the storm control function, see
"Configuring storm control on an Ethernet
To set storm suppression thresholds on one or multiple Ethernet interfaces:
Step
1.
Enter system view.
2.
Enter Ethernet interface.
3.
Set the broadcast
suppression threshold ratio.
4.
Set the multicast
suppression threshold ratio.
5.
Set the unknown unicast
suppression threshold ratio.
NOTE:
If you set a traffic suppression threshold for an interface in Ethernet interface view multiple times, the
threshold configured last takes effect.
Setting the statistics polling interval
To set the statistics polling interval globally or on an Ethernet interface:
Step
1.
Enter system view.
2.
Enter Ethernet interface view.
3.
Set the statistics polling
interval on the Ethernet
interface.
To display the interface statistics collected in the last polling interval, use the display interface command.
To clear interface statistics, use the reset counters interface command.
interface."
Command
system-view
interface interface-type
interface-number
broadcast-suppression { ratio | pps
max-pps | kbps max-kbps }
multicast-suppression { ratio | pps
max-pps | kbps max-kbps }
unicast-suppression { ratio | pps
max-pps | kbps max-kbps }
Command
system-view
interface interface-type
interface-number
flow-interval interval
8
Remarks
N/A
Use either command.
Optional.
By default, all broadcast traffic is
allowed to pass through.
Optional.
By default, all multicast traffic is
allowed to pass through.
Optional.
By default, all unknown unicast
traffic is allowed to pass through.
Remarks
N/A
N/A
Optional.
The default interface statistics
polling interval is 300 seconds.
Advertisement
Table of Contents
