Configuring Loopback And Null Interfaces; Configuring A Loopback Interface; Introduction To The Loopback Interface; Configuration Procedure - HP 6125G Configuration Manual
Layer 2 - lan switching
Hide thumbs
Also See for 6125G:
- Command reference manual (426 pages) ,
- Configuration manual (379 pages) ,
- Release note (60 pages)
Table of Contents
Advertisement
Configuring loopback and null interfaces
Configuring a loopback interface
Introduction to the loopback interface
A loopback interface is a software-only virtual interface. It delivers the following benefits:
The physical layer state and link-layer protocols of a loopback interface are always up unless the
•
loopback interface is manually shut down.
•
To save IP address resources, you can assign an IP address with an all-F mask to a loopback
interface. When you assign an IPv4 address whose mask is not 32-bit, the system automatically
changes the mask into a 32-bit mask. When you assign an IPv6 address whose mask is not 128-bit,
the system automatically changes the mask into a 128-bit mask.
You can enable routing protocols on a loopback interface, and a loopback interface can send and
•
receive routing protocol packets.
Because of the benefits mentioned above, loopback interfaces are widely used in the following
scenarios:
You can configure a loopback interface address as the source address of the IP packets that the
•
device generates. Because loopback interface addresses are stable unicast addresses, they are
usually used as device identifications. When you configure a rule on an authentication or security
server to permit or deny packets generated by a device, you can simplify the rule by configuring it
to permit or deny packets that carry the loopback interface address identifying the device. When
you use a loopback interface address as the source address of IP packets, be sure to perform any
necessary routing configuration to make sure that the route from the loopback interface to the peer
is reachable. All data packets sent to the loopback interface are treated as packets sent to the
device itself, so the device does not forward these packets.
Because a loopback interface is always up, it can be used in dynamic routing protocols. For
•
example, if you do not configure a router ID for a dynamic routing protocol, the highest loopback
interface IP address is selected as the router ID. In BGP, to prevent physical port failure from
interrupting BGP sessions, you can use a loopback interface as the source interface of BGP packets.
Configuration procedure
Step
1.
Enter system view.
2.
Create a loopback interface
and enter loopback interface
view.
3.
Set the interface description.
Command
system-view
interface loopback
interface-number
description text
15
Remarks
N/A
N/A
Optional
By default, the description of a loopback
interface is interface name Interface.
Advertisement
Table of Contents
