Safety instructions Carefully read these instructions to learn how the appliance works and how to care for it. Keep the instruction booklet. It will come in handy if you later sell the cabinet or give it to somebody else. These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance.
Before use Position and clean the cabinet as explained in the section "Installation". Check that the drain hose at the rear of the cabinet discharges into the drip tray. Before inserting the power plug into the outlet and switching on the cabinet for the first time, leave it standing upright for about 30 minutes, or for 4 hours if it was transported horizontally.
Measuring the temperature If the temperature is measured using a standard, single thermometer, this should be put in a glass of water centrally placed inside the cabinet. This will reflect the temperature inside the food products. Do not place the thermometer hanging or lying directly on the shelf.
Cabinet interior The shelves and door compartments are removable and can easily be re-arranged. Certain shelves must be lifted up by the rear edge to enable them to be removed. The lower door compartment and the glass shelf above the vegetable drawer must not be moved. They are required for proper air circulation inside the cabinet.
The built-in temperature display shows the warmest temperature inside the freezer. If the temperature is measured using a thermometer, put it between the products since this will reflect the real temperature in the frozen products. It is normal that the built-in temperature display shows a temperature slightly above that measured in other ways.
At about -12°C: Most food products can be immediately re-frozen. Ice cream is especially sensitive to temperature changes and should be consumed as soon as possible. At -9° -- -2°C: Food products should be prepared (cooked) prior to eating or re-freezing them. Freezing You need not press the fast-freezing button when freezing smaller quantities of food during any...
Cabinet interior Freezer drawers The freezer drawers make it easy to quickly and easily find the food package you want. To gain space, the drawers can be removed and the products can be put directly on the shelves. On all shelves, except the top shelf, it is possible to place products that protrude 20 mm from the front edge.
· When cleaning the cabinet, use a mild Protect the environment washing-up detergent. · Follow the advice in the section "Saving energy" · Hand over the cabinet packaging and discarded · The door gasket and coolant used in this fridges and freezers to a recycling station. cabinet will not harm the ozone layer.
Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. · do not place foodstuffs directly against the cold cooling plate.
Something Not Working Before contacting your local Service Force Centre check the following point: Problem Possible cause / Remedy " " is displayed in the temperature An error has occurred in measuring the temperature. Call your display. service representative. (The cooling system will continue to keep food products cold, but temperature adjustment will not be possible.) The yellow Action Freeze and red...
Too much frost and ice are produced. Make sure that the door is completely closed and that the insulating strip is complete and clean. Set a warmer temperature. The compressor operates continuously. Set a warmer temperature. Make sure that the door is completely closed and that the insulating strip is complete and clean.
Technical specification ER9012B/ Model ER9013B 297 l Volume fridge 82 l Volume freezer 595 mm Width 2000 mm Height 600 mm Depth 496 kWh/year Energy consumption Energy class 160W Rated power 12kg/24 hours Freezing capacity Installation Unpacking Unpack the cabinet and check that it is in good condition and free of any transport damage.
Installing the cabinet When two appliances are placed beside each other, the distances enclosed in the plastic wrapping should be glued between the appliances. As shown in the illustration. To obtain the best performance from the cabinet, ensure : · the cabinet is placed in a dry, cool place and is not exposed to direct sunlight.
Replace the cover washer on the handle. Model ER9012B 9. To transfer the handle. Unscrew the screws. Fit the handle onto the opposite side by turning it one half circle. Press the supplied plastic plugs into the holes to which the handle was previously fitted.