WARNINGS It is most important that this instruction book should be retained with the appliance for future refer- ence. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
¥ Do not place carbonated or fizzy drinks in the ¥ If the appliance has been transported horizontally, freezer as it creates pressure on the container, it is possible that the oil contained in the which may cause it to explode, resulting in compressor flows in the refrigerant circuit.
OPERATION ¥ If using a 100 mm plinth, fit the complete height compensation strip. Control Panel Alignment height of 870 mm ¥ If using a 190 to 220 mm plinth, make a shown. ¥ If using a plinth higher than 150 mm but less than 190 mm, cut the height compensation strip supplied with the appliance to the required depth and fit it between the plinth and the ventilation...
Appliance interior ¥ Once adjustment has been completed, open the doors and drill the door panels with a 2,5 mm bit through the hole in the hinge; fix with the screws (Fig. 8b) Cooked foods and meats, foods for daily use Door shelves Building the appliance in Butter and cheese...
Refrigerator compartment ¥ Fit bottom guide block G using two screws and fix the hinge with the screw in the vertical slot. ¥ Do not place hot food or drinks in the refrigerator; wait until they trave cooled to room temperature. ¥...
360,5 Fitting the door panels Superchill compartment ¥ The temperature in this compartment (from 0¡C to +3¡C) is kept constant by a special sensor. No ¥ Drill the door panels as shown in the diagram and adjustment is needed. fit the guide blocks. ¥...
POSITIONING Useful hints for freezing Thawing food ¥ Products to be frozen should be fresie and clean. Foods may be thawed in various ways, depending Height adjustment on their type and the size of pack. ¥ Pack foods in suitable family portions which can be used up all at once.
INSTALLATION MAINTENANCE If this appliance featuring magnetic door seals is Before carrying out any maintenance operations, to replace an older appliance having a spring including those described in this book, unplug the appliance from the mains supply. lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance.
TROUBLESHOOTING Periods of non operation If the appliance is to be out of use for some time, If something is not working properly, make sure that turn the main On/Off switch E to position Ç0È, allow all the instructions in this book trave been followed the appliance to defrost and thoroughly clean it.