Page 1
K û h l -- / G e f r i e r k o m b i n a t i o n / F r i d g e -- f r e e z e r / F r i g o f í c o -- C o n g e l a d o r / R é f r i g é r a t e u r -- C o n g é l a t i o n GEBRAUCHSANWEISUNG INSTRUCTION BOOK INSTRUZIONI D’USO NOTICE D’UTILISATION ER8509BX, ER8509BCRE, ER8509BSAN 818 16 10--04/2...
Safety instructions Your new fridge/freezer may have other functions compared to your previous one. Carefully read these instructions to learn how the appliance works and how to care for it. Keep the instruction booklet. It will come in handy if you later sell the cabinet or give it to somebody else. These warnings are provided in the interests of your safety.
Description of the Appliance Control Panel A B C D E E. Green indicator lamp A. Alarm shut-off button Lights when the freezer is operating. Used to turn the audible alarm off. F. Thermostat control B. Red warning lamp Use to switch on and set the desired temperature in Lights if it is too warm inside the cabinet.
Temperature inside the fridge A suitable temperature inside the fridge is approx. +5°C. If the thermostat control is set to a too cold temperature, food with a high water content may start to freeze if it has been placed in the coldest places in the fridge.
Alarms and other features Temperature alarm A red warning light will glow if the temperature continues to rise and a sound signal will start. The temperature alarm will go off it is warmer than the set temperature To avoid false alarms, there is a delay in the acoustic alarm with normal use.
Cabinet interior Wood interior Glass shelf with wood trim The shelf can be re--arranged if you so desires. Wood shelf The shelf can be re--arranged if you so desires. Small glass shelf with wood trim This shelf must be placed above the vegetable drawer.
Hints and Tips Saving energy · Make sure the door gasket is complete and always clean. · Pay careful attention to where the cabinet is placed. See the section "Installation". When Food Storage installed correctly, the cabinet will consume less ·...
To Change the Light Bulb The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. Fold the grille backward by unsnapping the front edge. Use a bulb of the same type, E14 socket, maximum rating of 25 W.
Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Remove the freezer drawers and place them on top of each other by turning every other drawer one half turn.
Page 10
It is too cold inside the refrigerator. Set a warmer temperature. Vegetables and other products that are easily frozen have been placed on a "too cold" shelf. See the chapter "Temperature inside the refrigerator". There is water on the cooling plate inside This is normal.
Sound level in cabinet is too high. The refrigerating system will always produce some sounds. A pulsing sound is heard when coolant is pumped inside the cooling pipes. A ticking sound from the thermostat can be heard when the compressor switches on and off. The sound level varies depending on the operation of the cabinet.
Technical specification ER8509BX, ER8509BCRE, Model ER8509BSAN 237 l Volume Refrigerator 82 l Freezer 595 mm Width 1750 mm Height 600 mm Depth 460 kWh/year Energy consumption Energy class 160W Rated power 12 kg/24 hours Freezing capacity Installation Electrical cord In the event of damage to the products' electrical...
Mounting the handles. Pool handle 1. Screw a handle attachment onto the handle bar. 2. Screw the other handle attachment on the cabinet door. 3. Put the handle with the handle attachment on the door and screw into place. Caution! Do not overtighten the screws (max 2 Nm) as you may damage the door handles.
Climate for an ambient temperature of classification +10°C to +32°C +16°C to +32°C +18°C to +38°C +18°C to +43°C Check that the drain hose at the rear of the cabinet discharges into the drip tray. If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the cabinet must be at least 10 mm to allow the door to open enough so that the shelves can be...
Door Reversal 1. Close the cabinet and remove the plug from the electrical socket. 2. Unscrew the handle. Firstly unscrew the handle attachment from the upper handle holder. Then loosen both handle holders from the door. 3. Remove the ventilation grille. There is a part on the grille that can be removed.