Making The Lp Conversion - GE JGP329 Installation Instructions Manual
30" sealed gas cooktop
Hide thumbs
Also See for JGP329:
- Owner's manual (36 pages) ,
- Installation instructions manual (33 pages) ,
- Installation instructions manual (32 pages)
Table of Contents
Advertisement
Installation
Instructions
MAKING THE LP CONVERSION
IF SOLD OUTSIDE THE U.S. AND CANADA:
,_tWt'_K|'_
| |'_qtJ : Ifyou wish to use this product
with Liquefied Petroleum (LP) gas containing greater
than 10% butane, you must purchase a butane
conversion kit. To order, please call 1.888.664.8403 or
1.787.276.4051.
Model
Butane Kit #
JGP940
WB28T10228
JGPZZ3 &
WB28T10283
PGP943
JGP329
WB28T10234
r_
SAFETY INFORMATION
YOU
SHOULD KNOW
The pressure regulator
and burner orifices are set
for natural gas. To use LP gas,
the regulator
and burner orifices must
be converted.
The LP orifice spuds for
the cooktop
burners can be located in the literature
package attached
to the regulator.
JLL,_L,I/IUi_I:
The cooktop, as shipped from
the factory, is set for use with natural gas. If you
wish to use your cooktop
with LP gas, you must
first replace the orifices and convert the pressure
regulator.
,AWARN ING:
Thisconversion
must be performed by a qualified installer
or gas supplier inaccordance withthe
manufacturer's instructions and all codes
and requirementsof the authority having
jurisdiction.
Failure to follow instructions
could
result in serious injury or property damage. The
qualified
agency performing
this work assumes
responsibility
for the conversion.
,_&L,_!,J|IUI_I:
The following
adjustments
must be made beforeturning
on the burner. Failure to do so could result in
seriousinjury. Be sure pressureregulator has been
converted as describedinStep 2.
TOOLS YOU WILL NEED
FOR LP CONVERSION
Phillips-Head
7mm Nutdriver
Screwdriver
Pliers
Safety Glasses
No. !5 Torx-Head
Driver
Small Flat-Head
Screwdriver (4mm or
5/]2" tip size, 60mm
long)
13
[2]
B]
[]
ADJUST YOUR COOKTOP FOR USE
WITH LP GAS
Disconnect
all electrical
power, at the main
circuit breaker or fuse box.
Shut off the gas supply to the cooktop
by closing the manual shut-off valve.
Adjust the pressure regulator,
by the following
instructions:
* Unscrew the cap.
* Place your thumb against the flat side of the
spring retainer and press down to remove
the retainer.
* Carefully look at the spring retainer to locate
the NAT or LP position.
Cap
Gasket
NAT.
Position
Position
Pressure Regulator
, Turn the spring retainer over so that LP is
showing on the bottom.
, Snap the retainer back into position.
, Screw the cap back onto the regulator.
Advertisement
Table of Contents
