Connecting with a 21-pin Scart cable
AV1
21-pin Scart socket
AC IN~
VCR
4
AC mains lead
TV
Antenna input
2
3
21-pin
Scart cable
4
AC mains lead
8
Follow the steps
described below.
1
Antenna
RF IN
Disconnect power to
Antenna input
all devices.
Connect antenna to the
1
RF IN (Antenna input)
connector of the VCR.
RF OUT
Antenna output
2
Connect the VCR's RF OUT
(Antenna output) to the
television set's antenna input
connector.
3
Connect the VCR's AV1 socket
(21-pin Scart socket) to the TV
set's Scart In socket.
RF coaxial cable
Connect VCR and TV set to
4
the AC mains supply.
VCR Auto Setup with 21-pin Scart cable
(Automatic tuning)
Turn on your television set.
With the Stand-by/on switch turn on the VCR.
The Country menu appears.
With the arrow buttons
select the according country, and
confirm by pressing ENTER.
Automatic tuning for all receivable TV stations begins.
Approximate duration is 5 minutes.
If menu Clock set appears
If time and date are not transmitted by a TV station, they must be set
manually.
Enter Time and Date with
save with ENTER.
Mind that a wrong date or time will influence the programmed
recording of TV programmes (don't forget to change summer time
and winter time).
After running the automatic tuning Time and Date must be set manually.
Enter Time and Date with
save with ENTER.
SV121 HV61 HV51 MV21 MV16
If the Country menu does not
appear after turning the device
on, you may reset the device to
its factory defaults (page 17).
Upon doing so the VCR Auto
Setup will start again.
SV121 HV61
HV51
MV21
MV16
...
or
, then
1
2
3
0
SV121 HV61
HV51
MV21
MV16
...
or
, then
1
2
3
0