Kenwood KDC-152 Instruction Manual
Cd-receiver
Hide thumbs
Also See for KDC-152:
- User manual ,
- Instruction manual (44 pages) ,
- Service manual (44 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Kenwood KDC-152
Summary of Contents for Kenwood KDC-152
-
Page 2: Table Of Contents
Kenwood dealer. controller (RC -405) • When you purchase external components, Listening to the other external check with your Kenwood dealer to make components sure that they work with your model and in your area. Function settings •... -
Page 3: Preparation
Preparation How to prepare the remote How to attach/detach the faceplate controller (RC-405) When you use the remote controller for the first time, pull out the insulation sheet. • Do not expose the faceplate to direct sunlight, excessive heat, or humidity. Also If the effectiveness of the remote avoid places with too much dust or the possibility of water splashing. - Page 5 When you press or hold the following button(s) ... • Turns on. • Turns off if pressed and held. Selects the available sources (TUNER, CD, AUX, STANDBY), if the power is turned on. • If the source is ready, playback also starts. "CO" is selectable only when disc is loaded.
-
Page 6: Getting Started
Getting started Canceling the display Adjusting the clock demonstration 1 Press the volume knob to enter [FUNCTION] mode. The display demonstration is always turned 2 Turn the volume knob to select on unless you cancel it. [SETTINGS], then press to enter. When you turn on the power (or after you 3 Turn the volume knob to select [CLOCK], reset the unit), the display shows:... -
Page 11: Troubleshooting
Troubleshooting Sound cannot be heard. • Check the cords and connections. "PROTECT" appears and no operations can be Check to be sure the terminals of the speaker leads are covered with done. insulating tape properly, then reset the unit. If "PROTECT" does not nearest service center. - Page 13 (Power control wire) control terminal in the vehicle. To the terminal that is grounded when either the telephone rings or during conversation. Brown (To connect the Kenwood navigation system, (Mute control wire) consult your navigation manual.) Red (Ignition wire) Yellow (Battery wire) ·------------~--------------~...
- Page 14 Connect the wiring harness to the unit. Other wiring connection has been completed earlier. (page 13) ....~.., ,.-(.··_· _ _ - . •.. <_._--_-_-_·t"-, t-·.·. _ _ ··.·--·---_ _ .. · · - - - _ - _ - _ - _ _ . ___ ------··----·-' Before attaching, make •...