Table of Contents
Advertisement
v Operator information panel release button (Optional): This release button is on
the advanced operator information panel. Push the blue release button and pull
out the light path diagnostics panel to view the light path diagnostics LEDs and
buttons. See "Operator information panel," "Light path diagnostics" on page
106, and "Light path diagnostics LEDs" on page 109 for more information about
light path diagnostics.
v Video connector: Connect a monitor to this connector. The video connectors on
the front and rear of the server can be used simultaneously.
Note: The maximum video resolution is 1600 x 1200 at 75 Hz.
v USB connectors: Connect a USB device, such as a USB mouse, keyboard, or
other device, to any of these connectors.
Operator information panel
The following illustrations show the location of the operator information panel and
the LEDs on the operator information panel respectively.
v Power-control button and power-on LED: Press this button to turn the server
on and off manually or to wake the server from a reduced-power state. The
states of the power-on LED are as follows:
– Off: AC power is not present, or the power supply or the LED itself has
failed.
– Flashing rapidly (4 times per second): The server is turned off and is not
ready to be turned on. The power-control button is disabled. This lasts
approximately 1 to 3 minutes.
Chapter 1. The IBM System x3530 M4 Type 7160 server
15
Advertisement
Table of Contents
Troubleshooting
