Setting Up The Monitor; Installing The Pedestal - HP ZR2040w User Manual
Hide thumbs
Also See for ZR2040w:
- Specifications (2 pages) ,
- User manual (64 pages) ,
- Product end-of-life disassembly instructions (8 pages)
Table of Contents
Advertisement
2
Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.
NOTE:
Be sure the master power switch, located on the rear panel of the monitor, is in the off
position. The master power switch turns off all power to the monitor.
Installing the Pedestal
NOTE:
Do not install the pedestal if the monitor will be used on a wall, swing arm, or other mounting
fixture; instead see
chapter.
CAUTION:
Pressure on the panel may cause non-uniformity of color or disorientation of the liquid crystals. If this
occurs the screen will not recover to its normal condition.
To assemble the ZR2040w, slide the pedestal upright into its base, as shown on the following page.
Figure 2-1
Mounting the Monitor to User-Supplied Support Hardware on page 14
Whenever you handle the monitor, take care not to touch the surface of the LCD panel.
Assembling the ZR2040w pedestal
in this
Installing the Pedestal
5
Hide quick links:
Advertisement
Table of Contents
