Network Configuration - Sanyo PLV-80 Series Owner's Manual
Pj-net organizer plus c
Hide thumbs
Also See for PLV-80 Series:
- Service manual (132 pages) ,
- Specifications (1 page) ,
- Owner's manual (60 pages)
Table of Contents
Advertisement
Chapter 2 Installation
Network configuration
Confirmation of the network menu
When installing this product to the projector, the network on-screen menu items for this
product are activated automatically. If not activated, the product may not have been
installed correctly. Please check item "Mounting" (+ p.18).
Configure the network
Before performing the network configuration, prepare network address numbers (IP
Address, Subnet Mask, Default Gateway, DNS) assigned to the projector. Ask your network
administrator for the network address.
For example, the case where the following network address is set up is explained.
IP Address
Subnet Mask
Default Gateway
DNS
The default network configuration is set as follows.
IP Address
Subnet Mask
Default Gateway
DNS
1
Selection of network menu
Turn on the projector and display the menu on the screen. Select network icon from the
main menu and then press SELECT button once. Check that the mode is "On". If not,
change mode to "On" using the point buttons (7,8).
✐ The network unit begins restarting each time the mode is set "On".
0
: 192.168.1.201
: 255.255.255.0
: 192.168.1.1
: 0.0.0.0
: 192.168.0.2
: 255.255.255.0
: 0.0.0.0
: 0.0.0.0
Select "On" or "Off"
with 7,8 button
Network icon
Advertisement
Table of Contents
