11. ENVIRONMENT CONCERNS ..........16 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler –...
ENGLISH SAFETY INSTRUCTIONS Before the installation and use of the ap- • The first time you use the appliance, pliance, carefully read the supplied in- make sure that there is no leakage. structions. The manufacturer is not re- • The water inlet hose has a safety valve sponsible if an incorrect installation and and a sheath with an inner mains ca- use causes injuries and damages.
Page 4
13 amp ASTA (BS • Do not drink and play with the water in 1362) fuse. the appliance. • Do not remove the dishes from the 1.3 Use appliance until the programme is completed. There can be detergent •...
Indicators Description Wash indicator. Rinse aid indicator. This indicator is off while the programme operates. Salt indicator. This indicator is off while the programme oper- ates. 4. PROGRAMMES Degree of Programme Duration Energy Water Programme soil phases (min) (kWh)
ENGLISH 5. OPTIONS 5.1 Acoustic signals 5. Wait until the programme indicator (A) goes off and the end indicator The acoustic signals operate in these comes on (the programme indicator conditions: (B) continues to flash). • When the programme is completed. •...
ENGLISH 6.2 Filling the salt container CAUTION! Only use dishwasher salt. Other products can cause damage to the appliance. Water and salt can come out from the salt container when you fill it. Risk of corrosion. To pre- vent it, after you fill the salt con- tainer, start a programme.
10 www.aeg.com 7. DAILY USE 1. Open the water tap. • Make soft the remaining burned food on the items. 2. Press the on/off button to activate the appliance. Make sure that the ap- • Put hollow items (cups, glasses and pliance is in setting mode.
Page 11
ENGLISH CAUTION! Use only detergents for dish- washers. Press the release button (B) to open the lid (C). Put the detergent in the compart- ment (A) . If the programme has a prewash phase, put a small quantity of deter- gent in the compartment (D).
12 www.aeg.com Starting a programme without 2. Press the delay button, the delay in- dicator goes off. delay start 3. Close the appliance door. The pro- 1. Open the water tap. gramme starts. 2. Press the on/off button to activate the appliance.
ENGLISH 8.1 Cleaning the filters Turn the filter (A) counterclockwise and remove it. To disassemble the filter (A), pull apart (A1) and (A2). Remove the filter (B). Wash the filters with water. Put the filter (B) to its initial position. Make sure that it assembles correct- ly under the two guides (C).
Page 14
14 www.aeg.com Alarm code Problem • The indicator of the set programme The appliance does not fill with water. flashes continuously. • The end indicator flashes 1 time in- termittently. • The indicator of the set programme The appliance does not drain the wa- flashes continuously.
Page 15
ENGLISH After the checks are completed, activate If other alarm codes show, contact the the appliance. The programme contin- Service. ues from the point of interruption. If the problem occurs again, contact the Service. 9.1 The washing results and drying results are not satisfactory Problem Possible cause Possible solution...
16 www.aeg.com Problem Possible cause Possible solution The quantity of detergent Make sure that you add the was too much. correct quantity of deter- gent in the dispenser be- fore you start a programme. Dry water drop The released quantity of...
Page 17
ENGLISH facility or contact your municipal appliances marked with the symbol office. with the household waste. Return the product to your local recycling...