C o n te n t Important safeguards Before using your vacuum cleaner Identifying parts of your vacuum cleaner How to use your accessories How to empty the dust container and maintain the HEPA filters How to maintain your vacuum cleaner (cleaning the brush roll, mini turbo nozzle, how to clear a blockage) Trouble shooting...
2. Examine the mains supply cable for damage (only after removing the plug from the socket outlet). 3. If there is any sign of damage to the supply cable it MUST be renewed. The repair MUST be carried out by an Electrolux Service Agent or a similar qualified person.
Never use vacuum cleaner • Close to flammable gases, etc. • On sharp objects. • On hot or cold cinders, lit cigarette butts, etc. • On fine dust, for instance plaster, concrete, flour. Power cord precautions • Regularly check that the plug and cord are not damaged. Never use the vacuum cleaner if the cord is damaged. • If the cord is damaged, it must be replaced only by an authorized Electrolux service centre in order to avoid a hazard. Damage to the vacuum cleaner’s cord is not covered by the warranty. • Never pull or lift the vacuum cleaner by the cord. All servicing and repairs must be performed by an authorized Electrolux service centre. Store the vacuum cleaner in a dry place.
How to use your accessories CAUTION: Do not place the cleaner on furniture or steps for any period of time as the brushroll may cause damage. Place the cleaner on the floor with the handle in the upright/storage position while using accessories. Do not allow the cleaner to tilt forward when using accessories. Before using accessories 1) Handle must be in upright position.
How to empty the dust container and maintain the HEPA filters READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. Moving parts! Power switch is marked for ON-OFF. DUSTBIN – Empty after each use Press lever to release bottom lid. Close bottom lid Debris will empty. until it clicks. FILTER EF91B – Replace or clean regularly with filter brush to maintain suction Filter EF91B Empty dustbin.
Page 9
If these conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum. After the 30 minute period, plug the vacuum back in and push the on/off switch On ( I ). If the vacuum still does not run, please call Electrolux Customer Care Helpline. Service Should you require service on your Electrolux vacuum, •...
Trouble shooting Cause Solution Problem Motor will not start. Power plug • Push plug securely into outlet, try another outlet or check circuit breaker. Power switch • Step on power switch to turn vacuum on. Thermal cut-off • See above. Vacuum does not clean •...
Page 12
Ph: (09) 9573 2220 Customer Service - Ph: 0508 730 730 www.electrolux.co.nz *Due to the Electrolux policy of continual product development; specifications, colours and details p/n 85217 of our products and those mentioned in this manual are subject to change without notice.