Component Compartment Airflow; Door Hinge Assemblies; Door Hinge Replacement - GE JCKSO6 Technical Service Manual

27-in. and 30-in. wall ovens

Hide thumbs

Table Of Contents

Table of Contents

3. Continue this process all the way around the

inner panel until all clips have been inserted.

4. With a small screwdriver, tuck the loose ends of

the gasket into the slots at the center bottom of

the door panel. Be sure to leave a 6-in. gap in

the gasket at the bottom of the door.

5. After the gasket has been installed, wipe a finger

around the outer perimeter of the gasket, press-

ing it up against the side of the inner panel. This

will assure that the gasket is fully seated.

Door Hinge Assemblies

The door hinge comes as a complete assembly.

For the hinges to operate properly, the hinge arms

must be perpendicular to the door liner and parallel

to each other with the door in the open position.

Door Hinge Replacement

1. Remove the door. Refer to Lift-Off Oven Door.

2. Remove 3 or 4 screws (depending on model)

from the bottom door frame.

3. Remove 2 screws from each side of the door,

and separate the door liner and the outer glass

assembly.

4. Remove 3 or 4 screws (depending on model)

from the door liner to remove each door hinge

assembly.

Note: When assembling, make sure the hinge

arms are parallel to each other and perpendicular

to the door liner. If not, the hinge may bind on the

receiving channel of the door.

Note: If the new hinge is not in the cocked and

locked position after installing, place the bottom of

the door against a firm surface and push the hinge

arm down to the cocked position. Pull the hinge

lock back against the door liner surface to lock the

hinge in this position.