Step 8: Door Installation - Thermador PD304 Installation Instructions Manual
Professional dual fuel ranges
Hide thumbs
Also See for PD304:
- Care and use manual (144 pages) ,
- Installation instructions manual (72 pages) ,
- Installation instructions manual (46 pages)
Table of Contents
Advertisement
Step 8: Door Installation
CAUTION
The door is heavy and requires two people to
handle it properly.
1. Insert the door hinge into the hinge pocket in the
front frame. When the door is properly installed,
the bottom edge will be parallel to the front of
the range and the hinge will click into position
and support the weight of the door.
2. Tip the door parallel to the floor to free the hinge
locking pin.
3. Carefully remove the pins. The door is now free
to close. Install the hold down bracket. Do not
tighten screw. (Retain pins for future door re-
moval.)
4. Adjust the door height so the latch lock lever and
spacer gauge enters the slot in the door liner as
the door is closing and the top of the door
should be parallel to the bottom of the control
panel. Tighten down screw on hold down bracket.
5. Oven door hinges seated and hold down bracket
is located in proper locked position. Now the
door opens and closes properly.
6. The toe kick panel should be mounted last to
prevent damage by the door.
Insert the door hinge into the hinge
Photo B.
pocket in the front frame.
Photo D
Bottom of Door
Height adjusting screw
Page 19
Fig. 15
Hinge Locking Pin
Photo C
Fig. 16
(Retain for future
door removal)
Advertisement
Table of Contents
