hit counter script
Sanyo EM-P410WS Service Manual

Sanyo EM-P410WS Service Manual

Microwave oven

Advertisement

SER
SERVICE MANUAL
SER
VICE MANUAL
VICE MANUAL
VICE MANUAL
SER
SER
VICE MANUAL
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING
SERVICING TO AVOID POSSIBLE EXPOSURE TO
(a) Do not operate or allow the oven to be operated with the door open.
(b) Make the following safety checks on all ovens to be serviced before activating the magnetron or other
microwave source, and make repairs as necessary :
(1) Interlock operation, (2) proper door closing, (3) seal and sealing surfaces (arcing, wear, and other damage),
(4) damage to or loosening of hinges and latches, (5) evidence of dropping or abuse.
(c) Before turning on microwave power for any service test or inspection within the microwave generating
compartments, check the magnetron, wave guide or transmission line, and cavity for proper alignment, integrity,
and connections.
(d) Any defective or misadjusted components in the interlock, monitor, door seal, and microwave generation and
transmission systems shall be repaired, replaced, or adjusted by procedures described in this manual before
the oven is released to the owner.
(e) A microwave leakage check to verify compliance with the Federal performance standard should be performed
on each oven prior to release to the owner.
Micr
Micr

Microwave Oven

Micr
Micr
W W W W W ARNING TO SER
ARNING TO SER
ARNING TO SER
ARNING TO SER
ARNING TO SERVICE TECHNICIANS

EXCESSIVE MICROWAVE ENERGY

owave Oven
owave Oven
owave Oven
owave Oven
Pr Pr Pr Pr Product Code No.
oduct Code No.
oduct Code No.
oduct Code No.
oduct Code No.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
VICE TECHNICIANS
VICE TECHNICIANS
VICE TECHNICIANS
VICE TECHNICIANS
File No :
File No :
File No :
File No :
File No :
EM-P410WS
EM-P410WS
EM-P410WS
EM-P410WS
EM-P410WS
(U.S.A.)
(U.S.A.)
(U.S.A.)
(U.S.A.)
(U.S.A.)
437 450 34
437 450 34
437 450 34
437 450 34
437 450 34
REFERENCE NO. SM-860236

Advertisement

Table of Contents
loading

Summary of Contents for Sanyo EM-P410WS

  • Page 1: Microwave Oven

    File No : File No : File No : SERVICE MANUAL VICE MANUAL VICE MANUAL VICE MANUAL VICE MANUAL Micr Micr owave Oven owave Oven EM-P410WS EM-P410WS Micr Microwave Oven Micr owave Oven owave Oven EM-P410WS EM-P410WS EM-P410WS (U.S.A.) (U.S.A.) (U.S.A.)
  • Page 2 In the area emitting the highest reading, switch the meter CAUTION CAUTION CAUTION CAUTION CAUTION to SLOW RESPONSE, and take a reading for minimum of three (3) seconds. We recommended the pattern outline For micr For micr For micr For micr For microwave ener owave ener owave ener...
  • Page 3 PERSONNEL. PERSONNEL. PERSONNEL. Door Latch The SANYO service center should have the designated detector to measure the microwave energy leakage Lever Stopper after the repair or adjustment. NOTE : Detector to be used at the service center is NARDA 8100, 8200 or the equivalent.
  • Page 4 4 . 4 . 4 . 4 . 4 . PRECAUTIONS AND REP PRECAUTIONS AND REP PRECAUTIONS AND REP AIR SER AIR SER VICE TIPS VICE TIPS 2 . 2 . 2 . 2 . 2 . SPECIFICA SPECIFICA SPECIFICA TIONS TIONS PRECAUTIONS AND REP...
  • Page 5: Circuit Diagram

    5. CIRCUIT DIAGRAM Figure 2 Figure 2 Figure 2 Figure 2 Figure 2 WIRING COLOR O : ORANGE B K : BLACK R : RED B L : BLUE W : WHITE Y : YELLOW - 3 -...
  • Page 6: Test Procedures And Troubleshooting

    6. TEST PROCEDURES AND TROUBLESHOOTING 6. TEST PROCEDURES AND TROUBLESHOOTING Filament Windings 6. TEST PROCEDURES AND TROUBLESHOOTING 6. TEST PROCEDURES AND TROUBLESHOOTING 6. TEST PROCEDURES AND TROUBLESHOOTING CAUTION CAUTION CAUTION CAUTION CAUTION - DISCONNECT THE POWER SUPPL - DISCONNECT THE POWER SUPPL Y CORD FROM Y CORD FROM - DISCONNECT THE POWER SUPPL...
  • Page 7 COMPONENT COMPONENT COMPONENT COMPONENT COMPONENT CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE RESUL RESUL RESUL RESUL RESULT T T T T Measur Measur Measure the r e the r e the r e the resistance : Acr esistance : Acr esistance : Acr esistance : Across two ter...
  • Page 8 COMPONENT COMPONENT COMPONENT COMPONENT COMPONENT CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE RESUL RESUL RESUL RESUL RESULT T T T T When When When When When When not When not When not When not When not Measur Measur Measur Measur...
  • Page 9 - 7 -...
  • Page 10 - 8 -...
  • Page 11 - 9 -...
  • Page 12 - 10 -...
  • Page 13 7 . 7 . 7 . 7 . 7 . DISASSEMBL DISASSEMBL DISASSEMBL DISASSEMBLY INSTRUCTIONS Y INSTRUCTIONS Y INSTRUCTIONS Y INSTRUCTIONS DISASSEMBL Y INSTRUCTIONS • • • • • OVEN MUST BE DISCONNECTED FROM ELECTRICAL OVEN MUST BE DISCONNECTED FROM ELECTRICAL OVEN MUST BE DISCONNECTED FROM ELECTRICAL OVEN MUST BE DISCONNECTED FROM ELECTRICAL B.
  • Page 14 C. C. C. C. C. REMOVING BLOWER MOTOR REMOVING BLOWER MOTOR REMOVING BLOWER MOTOR REMOVING BLOWER MOTOR REMOVING BLOWER MOTOR (Figures 11 (Top View) and 12). Duct (mag. exhaust) Blower Base (1) Remove screw securing the stay. (2) Disconnect all lead wires from the blower motor and H.V.
  • Page 15 E. E. E. E. E. REMOVING FUSE REMOVING FUSE REMOVING FUSE REMOVING FUSE REMOVING FUSE Remove the 20A fuse with a screwdriver. NOTE NOTE NOTE NOTE NOTE When replacing the 20A fuse, be sure to use an exact repair part. Control Base If the 20A fuse blows immediately, check the primary interlock switch, the relay 2 (on the control circuit board)
  • Page 16: Removing Door

    H. H. H. H. REMOVING DOOR REMOVING DOOR REMOVING DOOR REMOVING DOOR REMOVING DOOR J. J. J. J. J. REMOVING CA REMOVING CA REMOVING CA VITY COVER VITY COVER REMOVING CA REMOVING CAVITY COVER VITY COVER VITY COVER (Figure 16) (1) Remove 2 hex nuts securing the upper hinge.
  • Page 17 8 . 8 . 8 . 8 . 8 . EXPLODED VIEW AND P EXPLODED VIEW AND P EXPLODED VIEW AND P TS LIST TS LIST EXPLODED VIEW AND P EXPLODED VIEW AND PAR ARTS LIST TS LIST TS LIST CAVITY PARTS * * * ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING...
  • Page 18 SWITCHES AND MICROWAVE PARTS ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING APPROVED TESTING EQUIPMENT. CUSTOMERS SHOULD NOT ATTEMPT TO REPLACE PARTS IDENTIFIED BY A TRIPLE ASTERISK (***). Part No. Description Q’ty Part No. Description Q’ty 411 082 5201 SCR TPG TRS 4 x 10 Z1...
  • Page 19: Door Parts

    DOOR PARTS * * * ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING APPROVED TESTING EQUIPMENT. CUSTOMERS SHOULD NOT ATTEMPT TO REPLACE PARTS IDENTIFIED BY A TRIPLE ASTERISK (***). Part No. Description Q’ty Part No Description Q’ty 617 212 8368...
  • Page 20: Control Panel Parts

    CONTROL PANEL PARTS * * * ALL SERVICE ON MICROWAVE OVENS SHOULD BE PERFORMED BY A QUALIFIED TECHNICIAN USING APPROVED TESTING EQUIPMENT. CUSTOMERS SHOULD NOT ATTEMPT TO REPLACE PARTS IDENTIFIED BY A TRIPLE ASTERISK (***). Part No. Description Q’ty Part No. Description Q’ty 617 220 9500...
  • Page 21: Control Circuit Board

    CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD (Part No. 617 220 2990 617 220 2990 617 220 2990 617 220 2990 617 220 2990) - 19 -...
  • Page 22 CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD CONTROL CIRCUIT BOARD (Part No. 617 220 2990 617 220 2990 617 220 2990) 617 220 2990 617 220 2990 Key No. Order Part No. Description Q’ty Key No. Order Part No.
  • Page 23 9 . 9 . 9 . 9 . 9 . OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM OVERALL CIRCUIT DIAGRAM - 21 -...

This manual is also suitable for:

Em-p412wsEm-n107asEm-n107wsEm-n107bs

Table of Contents