1-11. How to Eject a Cassette Tape
Manually
n
Be sure to set the POWER switch to OFF, unplug the
power cord or remove the battery before starting any of the
following procedure to protect inside of the unit from
damage.
1. Open the drop protection (ME) of the outside panel
assembly in the direction of the arrow.
2. Align tip of a philips (+) screwdriver with the manual
eject gear (A) tooth and push the manual eject gear (A)
to rotate the manual eject gear (A) in the clockwise
direction.
n
When rotating the manual eject gear (A), check to see
that a tape is wound onto the cassette reel.
3. Rotate the manual eject gear (A) until the front lid
assembly is opened. When the front lid assembly is
opened, take out a cassette tape.
Front lid assembly
HDW-750/750CE V1
Outside panel
assembly
Drop protection (ME)
Manual
eject
Philips (+)
gear (A)
screwdriver
Rotate it while
pushing in.
(Clockwise direction)
1-11. How to Eject a Cassette Tape Manually
m
. When the front lid assembly is opened, never rotate the
manual eject gear (A).
. How to close the front lid assembly
The front lid assembly cannot be closed and locked if the
manual eject gear (A) is completely rotated opening the
front lid assembly. Close the front lid assembly either by
rotating the manual eject gear (A) by 2 or 3 turns in the
counter-clockwise direction while pushing in the manual
eject gear (A), or by turning off the main power and then
back on.
If the front lid assembly cannot be opened even
though the manual eject gear (A) is rotated
1. Remove the outside panel assembly.
(Refer to Section 1-4.)
2. While raising up the cassette lid of a cassette tape,
move up the cassette compartment assembly.
(Refer to Section 1-9.)
3. Take out a cassette tape with care not to damage a tape
inside.
1-27