hit counter script
Toro 22203TE Operator's Manual
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower
  5. 22203TE
  6. Operator's manual
Toro 22203TE Operator's Manual

Toro 22203TE Operator's Manual

66cm heavy-duty rear bagger lawn mower
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Form No. 3364-357 Rev B
66cm Heavy-Duty Rear Bagger
Lawn Mower
Model No. 22203TE—Serial No. 312000001 and Up
To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com.
Original Instructions (EN)

Advertisement

Table of Contents
loading

Related Manuals for Toro 22203TE

Summary of Contents for Toro 22203TE

  • Page 1 Form No. 3364-357 Rev B 66cm Heavy-Duty Rear Bagger Lawn Mower Model No. 22203TE—Serial No. 312000001 and Up To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com. Original Instructions (EN)

  • Page 2: Table Of Contents

    Safety ................3 the product properly and safely. General Safety ............3 Sound Pressure............. 5 You may contact Toro directly at www.Toro.com for Sound Power ............5 product and accessory information, help finding a dealer, Vibration, Hand/arm ........... 5 or to register your product.

  • Page 3: Safety

    Servicing the Air Filter........18 comply with these safety instructions. Changing the Engine Oil ........19 Toro designed and tested this machine for reasonably Servicing the Spark Plug ........20 safe service; however, failure to comply with the Fuel System Maintenance ........21 following instructions may result in personal injury.

  • Page 4: Maintenance And Storage

    • If gasoline is spilled, do not attempt to start the engine but move the machine away from the area of spillage and avoid creating any source of ignition • Slopes: until gasoline vapors have dissipated. – Do not mow excessively steep slopes. •...

  • Page 5: Sound Pressure

    Measured vibration level for the right hand = 2.5 m/s • To ensure the best performance and safety, Uncertainty Value (K) = 1.3 m/s purchase only genuine Toro replacement parts and accessories. Do not use will-fit parts and The measured values were determined according to the accessories;...
  • Page 6 110-4977 115-4207 1. Thrown object hazard—do not operate the machine without 1. Read the Operators 3. Lubricate the transmission a bag in place. Manual. every 50 hours. 2. Lubricate the drive wheel pivot arms every 50 hours. 110-4978 1. Warning—read the Operator's Manual. 121–1449 2.

  • Page 7: Setup

    Setup Use only high-quality SAE 30 or SAE 10W30 weight detergent oil that has the American Petroleum Institute (API) service classification SF, SG, SH, or SJ. Note: Determine the left and right sides of the machine from the normal operating position. Oil Capacity of the Engine With oil filter 0.89 liters (30 ounces)

  • Page 8: Product Overview

    Product Overview oil level on the dipstick reads Full; refer to Draining the Engine Oil (page 19). C. If the oil level reading is approximately at the Full mark, insert the dipstick into the filler neck and turn the cap clockwise by hand until it is tight. Figure 5 1.

  • Page 9: Operation

    Operation Note: Determine the left and right sides of the machine from the normal operating position. Each time before you mow, ensure that the self-propel drive, the blade-control bar, and blade-control lever operate properly. When you release the blade-control bar, the blade and self-propel drive should stop. If they do not, contact an Authorized Service Dealer.
  • Page 10 Important: Do not add oil to the gasoline. DANGER Important: Do not use methanol, gasoline When fueling, under certain circumstances, a static containing methanol, gasohol containing more charge can develop, igniting the gasoline. A fire or than 10% ethanol, premium gasoline, or white gas. explosion from gasoline can burn you and others Using these fuels can damage the engine's fuel and damage property.

  • Page 11: Starting The Engine

    3. Fill the fuel tank with unleaded gasoline to within 4. Move the ground-speed-control lever to the Neutral 6 to 13 mm (1/4 to 1/2 inch) from the top of the (N) position. tank. Do not fill into the filler neck because the 5.

  • Page 12: Operating The Traction Drive

    2. Move the ground-speed-control lever to the desired gear position. 3. Squeeze the traction-control bar against the handle (Figure 15). Figure 15 Figure 13 Disengaging the Traction Drive Disengaging the Blade Release the traction-control bar. Release the blade-control bar. Checking the Blade-Brake Important: When you release the blade-control bar, the blade should stop within 3 seconds.

  • Page 13: Adjusting The Cutting Height

    DANGER If the blade-brake clutch system is not working, the blade will continue to rotate when you release the blade-control bar. You could come into contact with blade, causing serious injury. • Ensure that the blade brake clutch works properly before each use. •...

  • Page 14: Using The Grass Bag

    • If the machine strikes an object or starts to vibrate, immediately stop the engine, disconnect the wire from the spark plug, and examine the machine for damage. • For best performance, install a new Toro blade Figure 18 before the cutting season begins. Maintain a sharp 1. Rear door 2.

  • Page 15: Cutting Grass

    Cutting Grass • Cut only about a third of the grass blade at a time. • When cutting grass over 15 cm (6 inches) tall, mow at the highest cutting-height setting and walk slower; then mow again at a lower setting for the best lawn appearance.

  • Page 16: Maintenance

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 8 hours • Check the engine oil level. •...

  • Page 17: Premaintenance Procedures

    Premaintenance Lubrication Procedures Lubricating the Pivot Arms Preparing for Maintenance Service Interval: Every 50 hours Yearly or before storage 1. Move the machine to a level surface. 1. Refer to Preparing for Maintenance (page 17). 2. Stop the engine and wait for all moving parts to stop. 2.

  • Page 18: Engine Maintenance

    Engine Maintenance Servicing the Air Filter Service Interval: Before each use or daily Every 25 hours—Clean the foam pre-filter. Every 300 hours—Replace the paper filter (more frequently in dusty conditions). Important: Do not operate the engine without the air filter assembly; extreme engine damage will occur.

  • Page 19: Changing The Engine Oil

    8. Wrap the foam pre-filter around a new paper filter; 7. If you are not changing the oil filter this time, set them on the base. connect the wire to the spark plug. 8. Recycle the used oil according to local codes. 9.

  • Page 20: Servicing The Spark Plug

    Filling the Engine with Oil A. If the oil level reading is below the Add mark on the dipstick, slowly pour oil into the oil-fill Important: This machine does not come with oil hole to raise the oil level to the Full mark on the in the engine.

  • Page 21: Fuel System Maintenance

    Fuel System Drive System Maintenance Maintenance Emptying the Fuel Tank Adjusting the Self-propel Drive Service Interval: Every 50 hours Service Interval: Every 75 hours Every 300 hours If the machine does not self-propel or has a tendency to creep forward when the traction-control bar is more 1.

  • Page 22: Controls System Maintenance

    Blade Maintenance Controls System Maintenance Maintaining the Cutting Blade Adjusting the Blade-Brake Always mow with a sharp blade. A sharp blade cuts cleanly and without tearing or shredding the grass blades. Cable 1. Stop the engine and wait for all moving parts to stop. Service Interval: Before each use or daily 2.

  • Page 23: Balancing The Blade

    Installing the Blade or bystander's area, resulting in serious personal injury or death. 1. Install a sharp, balanced Toro blade, the washer, anti-scalp cup, and blade nuts. • Inspect the blade periodically for wear or damage.

  • Page 24: Cleaning

    Cleaning Note: The blade will draw in water and wash out clippings. Let the water run until you no longer see clippings being washed out from under the housing. Cleaning under the Belt Cover 4. Disengage the blade, stop the engine and wait for all moving parts to stop.

  • Page 25: Storage

    Storage 2. Clean any dirt and chaff from the engine, cooling fins, and recoil-starter vents. To prepare the machine for off-season storage, perform 3. Remove grass clippings, dirt, and grime from the the recommended maintenance procedures. Refer to external parts of the engine, the shrouding, and the Maintenance.

  • Page 26: Troubleshooting

    Troubleshooting Problem Possible Cause Corrective Action The engine does not start 1. The wire is not connected to the spark 1. Connect the wire to the spark plug. plug. 2. The throttle lever is not in the Choke 2. Move the throttle lever to the Choke position.
  • Page 27 Spypros Stavrinides Limited Cyprus 357 22 434131 Surge Systems India Limited India 91 1 292299901 T-Markt Logistics Ltd. Hungary 36 26 525 500 Toro Australia Australia 61 3 9580 7355 Toro Europe NV Belgium 32 14 562 960 374-0269 Rev C...
  • Page 28 Toro's option, under warranty at no cost for parts and labor. Frame failure due to misuse or abuse and failure or repair required due to rust or corrosion are not covered.

Table of Contents