Table of Contents
Advertisement
RAIN MASTER
®
Omit by Date: Yes or No. If set to Yes, the specified program will not irrigate on days
set under the Omit by Date/s command, under Setup-->Omit by Date.
If set to No, any and all Omit by Date/s will be ignored.
Overlap Protection: Yes or No. Overlap protection prevents programs from running
on top of each other. This is handy to prevent too many stations from activating at
once and also to prevent two programs activating the same station at the same time.
Continuous Cycle: Yes or No. Continuous Cycle runs an irrigation program over and
over again during a user-defined Cycle Start and End time. The Cycle Delay is how
long the cycle waits, in minutes, before starting again. It is similar to setting Cycle and
Soak for an individual station, but for an entire program.
If Continuous Cycle is turned on for a program, it is necessary to go back to
the program's Start Times and define the Cycle Start and Cycle
End times .
A twelve hour water window defined during which
Over-Water Limit: Warning or Stop. If the monthly irrigation limit is exceeded,
this option determines if the DX3 controller generates an alert or stops watering
completely.
42
Program 1 Start Times
Cycle Start / End
06:30AM
06:30PM
Program 1 will run over and over.
Chapter 6: Program Entry
DX3 User Manual
WED 5:43:40 PM
- Quick Links:
- Flow
- Master Valves & Pumps
Hide quick links:
Advertisement
Table of Contents
