Optimizing Motor Starting; Advanced Commissioning - Siemens SINAMICS G110M Operating Instructions Manual
Distributed converter for simogear geared motors
Hide thumbs
Also See for SINAMICS G110M:
- Operating instructions manual (428 pages) ,
- Original instructions manual (344 pages) ,
- Function manual (244 pages)
Table of Contents
Advertisement
Additional information on U/f characteristics can be found in the parameter list and in the
function diagrams 6300 ff of the List Manual.
6.5.1.3
Optimizing motor starting
Setting the voltage boost for U/f control
After selection of the V/f characteristic, no further settings are required in most applications.
In the following circumstances, the motor cannot accelerate to its speed setpoint after it has
been switched on:
● Load moment of inertia too high
● Load torque too large
● Ramp-up time p1120 too short
To improve the starting behavior of the
motor, the V/f characteristic can be
raised at low speeds.
The inverter raises the voltage in ac-
cordance with the starting currents
p1310 ... p1312.
The adjacent diagram shows the result-
ing voltage boost using a linear charac-
teristic as an example.
Requirements
● Set the ramp-up time of the ramp-function generator to a value 1 s (< 1 kW) ... 10 s
(> 10 kW), depending on the power rating of the motor .
● Increase the starting current in steps of ≤ 5 %. Excessively high values in p1310 ... p1312
can cause the motor to overheat and switch off (trip) the inverter due to overcurrent.
If the message A07409 appears, you must not increase any of the parameters.
Procedure
Proceed as follows to set the voltage boost:
1. Switch off the motor with a setpoint of just a few revolutions per minute.
2. Check whether the motor rotates smoothly.
3. If the motor rotates eccentrically or even stops, increase the voltage boost p1310 until the
motor rotates smoothly.
4. Accelerate the motor to the maximum speed with maximum load.
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 06/2016, FW V4.7.6, A5E31298649B AG
Advanced commissioning
6.5 Motor control
181
Advertisement
Table of Contents
