Thermador Pro Grand PRD304EG Service Manual page 27

Hide thumbs Also See for Pro Grand PRD304EG:

Table of Contents

Service Manual for Thermador Pro Grand Dual Fuel Ranges:

7. Remove the thermostat bulb by carefully pulling it out of the

retaining bracket (see Figure 42). If necessary, you can remove

and retain the two screws from the retaining bracket to remove in

order to facilitate the removal of the bulb.

NOTE: After removing the thermostat bulb from retaining bracket,

do not push the bulb through the receptacle in the element tray

yet.

Figure 42: Removing the Thermostat Bulb from Retaining Bracket

Retaining bracket

Thermostat bulb

58300000157422_ARA_EN_A

PRD304EG, PRD364EDG, PRD364EDPG, PRD364ELG, PRD366EG, PRD366EPG, PRD484ECG, PRD484EEG, PRD486EDG, PRD486EDPG, PRD486ELG

8. Disconnect the 1/4 inch spade connectors of both (right and left)

element wires. You may have to pull the element wires out a bit to

access the connectors – while doing this, be careful not to

damage the element wires.

9. Remove the two screws from the element tray (see Figure 43).

The insulation support bracket is now detached from under the

element tray (see Figure 44, page 29).

Figure 43: Screws on the Element Tray

Screws (2) holding element to tray

Fiberglass

Wear gloves when handling fiberglass insulation

Page 28 of 95

Table of Contents

Show Quick Links

Table of Contents

Troubleshooting