Table of Contents
Advertisement
7.2.6 Number of Digits Displayed (
This function allows you to switch the number of digits after the decimal point in the digital dis-
play section.
<Reference>
● Digital numbers are displayed right-justified, regardless of the specified number of digits displayed.
● Any numbers after the specified number of digits displayed are displayed in rounddown calculations.
Setting method
Hold down for 2 seconds
Setting item
Number of digits displayed (DIGIT)
<Reference>
Changing the number of digits displayed has no influence on judgment output and measured val-
ues read through communication.
WUME-HGT-3
Three digits after the
decimal point
CALC: Displayed for master units only
Three digits after the decimal place (0.001)
Two digits after the decimal place (0.01)
One digit after the decimal place (0.1)
Setting up Extended Functions
)
Two digits after the
decimal point
Finalize
Set value
One digit after the
decimal point
ALL IN / INTF.PR: Displayed for master units only
: Select
0.001
Default value
7-31
Advertisement
Table of Contents
Troubleshooting
