Table of Contents
Advertisement
Basic Usage
5.3 Explanation of Basic Operation
5.3.1 Checking the Beam Axis
Check the beam axis to see if the emitter and receiver of the sensor head are installed correctly.
For the controller, you can check the beam axis using the digital display section / MAIN (white),
digital display section / SUB (green), and circle meter (orange or green).
For the sensor head, you can check the beam axis using the beam axis adjustment indicator
/ TOP part and beam axis adjustment indicator / BOTTOM part for the receiver. (Except for
HG-T1110)
How to display the screen for checking the beam axis
(Beam axis adjustment mode)
Hold down the
key and
key simultaneously on the operation unit of the controller for two
seconds.
To check the beam axis using the controller
Digital display section / SUB
Guide mark / arrow keys
Guide mark / Enter
Circle meter
Bar mark
TOP mark
BOTTOM mark
If the beam axis is aligned, all LED segments of the circle meter on the left side of the display
unit lights up in green.
At the same time, the bar mark in the middle of the display section / MAIN lights up in white.
The guide mark / Enter on the right side of the display section also lights up in white.
WUME-HGT-3
5-7
Advertisement
Table of Contents
Troubleshooting
