Toro Greensmaster 1018 Service Manual page 114
Hide thumbs
Also See for Greensmaster 1018:
- Operator's manual (36 pages) ,
- Installation instructions manual (20 pages) ,
- Operator's manual (60 pages)
Table of Contents
Advertisement
Removing the Clutch Cable (continued)
Installing the Clutch Cable
Controls, Wheels and Accessories : Service and Repairs
B. Remove the retaining ring (4) that secures the clutch cable eyelet (3) to
the clutch lever (5) and slide and remove the clutch cable eyelet from
the clutch lever.
4. Remove the control cover and lower cover from the handle assembly to allow
access to upper end of the clutch cable (item 1 in
5. Remove the clutch cable (1) from the link assembly (7) as follows:
A. Loosen the lower cable jam nut (2) that secures the clutch cable to the
upper receiver weldment (9). Slide the clutch cable from the upper
receiver weldment.
B. Remove the cable spring (3) from the link assembly (7). Note the
orientation of cable spring hook on the shaft assembly for assembly
purposes.
6. Remove the clutch cable (1) from the machine.
1. Secure the clutch cable (item 1 in
follows:
A. Install the cable spring (3) to the link assembly. Orientate the cable spring
hook end toward front of the machine.
B. Slide the cable housing into the upper receiver weldment (9). Ensure that
the jam nut (2), flat washer and lock washer are on both sides of the
bracket. Adjust jam nuts so that equal amount of cable threads are visible
above the jam nuts. Leave the jam nuts snug until final cable adjustment.
2. Route the clutch cable (item 1 in
the cable as follows:
A. Slide the cable eyelet (3) to the clutch lever (5) and secure with a
retaining ring (4).
B. Position the clutch cable (1) to the casting slot of the engine base with a
jam nut (2), flat washer and a lock washer on each side of the slot.
3. Make final adjustment of the clutch cable at the clutch cable lever assembly.
Adjust the cable jam nuts to remove the slack in the clutch cable.
4. Check the clutch cable adjustment; refer to Operator's Manual.
5. Install the lower cover and control cover to the handle assembly.
6. Attach the spark plug wire to the engine spark plug.
Figure
52) to the clutch lever assembly as
Figure
53) to the transmission and install
Page 7–10
Figure
52).
Greensmaster
®
1018/1021/1026
18238SL Rev B
- Quick Links:
- Maintenance and Service
- Reel Drive Assembly
Hide quick links:
Advertisement
Chapters
Table of Contents
