Toro Greensmaster 1018 Service Manual page 169
Hide thumbs
Also See for Greensmaster 1018:
- Operator's manual (36 pages) ,
- Installation instructions manual (20 pages) ,
- Operator's manual (60 pages)
Table of Contents
Advertisement
Servicing the Gear Box (continued)
Greensmaster
®
1018/1021/1026
18238SL Rev B
Note: Refer to
Figure 87
1. Remove the drain/fill plug and drain the oil from the gear box.
2. Remove the 4 socket-head screws and separate the gear box cover and
housing. Remove and discard the cover gasket.
3. Slide the sun gear, ring gear, and planet gears from the pins on the gear
box housing.
4. Continue to disassemble the gear box as necessary.
Use the 1−3/8 inch flats on the input shaft to prevent the input shaft
from rotating during drive adapter removal and installation. DO NOT
use the 1/2 inch hex on the input shaft for drive adapter removal or
installation as input shaft damage may occur.
5. If the drive adapter requires replacement, apply high strength thread locker
(Loctite 243 or equivalent) to the 5/8 inch threads of the drive adapter and
tighten the adapter from 150 to 163 N∙m (110 to 120 ft-lb).
6. Carefully clean all the gasket material from the gear box housing and cover.
7. Inspect the V-ring, seals, bearings, gears, and bushings in the gear box
assembly. Replace the damaged or worn components as necessary.
8. If the sun gear, ring gear, or the gear box housing bearings are replaced,
press the bearings all the way to shoulder into the part.
9. If the flange bushings are replaced, ensure that the flange bushing is fully
seated against the part.
10. Assembly the gearbox.
• Ensure that all the retaining rings and O-rings are fully seated in the ring
groove during assembly.
• Lubricate the seal lips and O-rings before installing the shafts.
• Lubricate the planet gear and sun gear pins in the gear box housing with
the gear oil prior to installing the gears.
11. Clean the gasket surface on the gear box housing and cover with the solvent
and install new gasket.
12. Fit the gear box cover over dowel pins and install the 4 socket-head screws.
Tighten the screws from 1.7 to 4.5 N∙m (15 to 40 in-lb). In an alternating
cross pattern, tighten the screws from 8.4 to 9.6 N∙m (75 to 85 in-lb).
13. Fill the gear box with 80W−90 gear oil and tighten the drain/fill plug from
4 to 5 N∙m (32 to 42 in-lb).
The gear box oil capacity is 50 ml (1.7 fluid ounces).
14. Operate the groomer gear box by hand to check for proper operation prior to
installation.
during this procedure.
CAUTION
Page 9–7
Universal Groomer (Optional): Service and Repairs
- Quick Links:
- Maintenance and Service
- Reel Drive Assembly
Hide quick links:
Advertisement
Chapters
Table of Contents
