Fujitsu LifeBook P1610 Technical Procedure
Bluetooth board replacement
Hide thumbs
Also See for LifeBook P1610:
- User manual (128 pages) ,
- Bios manual (28 pages) ,
- Technical procedure (9 pages)
Advertisement
Quick Links
LifeBook P1610
Bluetooth Board Replacement
ESD Precautions are required when working on this LifeBook computer.
Make sure the LifeBook is turned off before beginning this procedure.
1. Turn the LifeBook over and
remove the battery
3. Release the cable by flipping the
latch up.
2. Extract these 3 screws from the
Hard Disk Drive cover and lift it off.
4. Lift the Drive out.
Advertisement
Related Manuals for Fujitsu LifeBook P1610
Summary of Contents for Fujitsu LifeBook P1610
- Page 1 LifeBook P1610 Bluetooth Board Replacement ESD Precautions are required when working on this LifeBook computer. Make sure the LifeBook is turned off before beginning this procedure. 1. Turn the LifeBook over and 2. Extract these 3 screws from the remove the battery Hard Disk Drive cover and lift it off.
- Page 2 5. Extract 11 screws from the lower 6. Extract 2 screws from the rear of case. the LifeBook. 7. Open the LifeBook and lay it flat. 8. Use a plastic pry tool to remove the keyboard upper trim. 9. Lift the top edge of the keyboard 10.
- Page 3 13. Turn the Display back and lay it 14. Disconnect 2 Display cables from down. the system board and the 2 antenna cables from the WLAN Card. 15. Extract 2 screws from the Display 16. Lift the Display off the lower hinge.
- Page 4 21. Extract 1 screw from the 22. Transfer the ribbon cable from Bluetooth board and lift it out. the defective board, insert the new one and secure it with 1 screw. 23. Connect the Bluetooth ribbon 24. Place the upper case and cable, the Bluetooth antenna cable connect the ClickPoint button cable and the IO Board ribbon cable.
- Page 5 29. Tilt the display up and rotate it ¼ 30. Slide the lower hinge cover into turn place. 31. Turn the Display back and lay it 32. Plug in the cables for the down. keyboard and ClickPoint. 33. Turn the keyboard over and slide 34.
- Page 6 37. Insert 11 screws into the lower 38. Insert the Hard Drive. case. 39. Press the latch down to lock the 40. Replace the Drive cover and cable into place. secure it with 3 screws. 41. Replace the battery.