Fujitsu LifeBook P1610 Technical Procedure

Lcd/digitizer replacement

Hide thumbs Also See for LifeBook P1610:

Download this manual

LifeBook P1610

LCD/Digitizer Replacement

ESD Precautions are required when working on this LifeBook computer.

Make sure the LifeBook is turned off before beginning this procedure.

1. Turn the LifeBook over and

remove the battery

3. Extract 8 screws from the front of

the display.

2. Remove 8 screw covers from the

front of the display.

4. Using the plastic pry tool pry

around the perimeter of the display

to release the front cover from the

rear.

Page 1 LifeBook P1610 LCD/Digitizer Replacement ESD Precautions are required when working on this LifeBook computer. Make sure the LifeBook is turned off before beginning this procedure. 1. Turn the LifeBook over and 2. Remove 8 screw covers from the remove the battery front of the display.
Page 2 5. Gently slide the pry tool between 6. Lift the front cover off. the screen and the front cover to release the tape. 7. Extract 2 screws from the power 8. Disconnect the 2 cables from the switch board and turn it over. board and lift it out.
Page 3 13. Connect the LCD cable, tape it 14. Secure the LCD with 3 screws. down and place the LCD into the rear cover. 15. Connect the 2 cables to the 16. Secure it with 2 screws. power switch board and place it into the rear cover.
Page 4 21. Replace the battery.