Fujitsu LifeBook P1610 Technical Procedure
Lower case replacement
Hide thumbs
Also See for LifeBook P1610:
- User manual (128 pages) ,
- Bios manual (28 pages) ,
- Technical procedure (9 pages)
Advertisement
Quick Links
LifeBook P1610
Lower Case Replacement
ESD Precautions are required when working on this LifeBook computer.
Make sure the LifeBook is turned off before beginning this procedure.
1. Turn the LifeBook over and
remove the battery
3. Release the cable by flipping the
latch up.
2. Extract these 3 screws from the
Hard Disk Drive cover and lift it off.
4. Lift the Drive out.
Advertisement
Related Manuals for Fujitsu LifeBook P1610
Summary of Contents for Fujitsu LifeBook P1610
- Page 1 LifeBook P1610 Lower Case Replacement ESD Precautions are required when working on this LifeBook computer. Make sure the LifeBook is turned off before beginning this procedure. 1. Turn the LifeBook over and 2. Extract these 3 screws from the remove the battery Hard Disk Drive cover and lift it off.
- Page 2 5. Extract 11 screws from the lower 6. Extract 2 screws from the rear of case. the LifeBook. 7. Open the LifeBook and lay it flat. 8. Use a plastic pry tool to remove the keyboard upper trim. 9. Lift the top edge of the keyboard 10.
- Page 3 13. Turn the Display back and lay it 14. Disconnect 2 Display cables from down. the system board and the 2 antenna cables from the WLAN Card. 15. Extract 2 screws from the Display 16. Lift the Display off the lower hinge.
- Page 4 21. Disconnect the IO Board cable, 22. Disconnect the CPU fan cable the Bluetooth cable, and the DC from the system board. power cable from the system board. 23. Extract 2 screws from the heat 24. Extract 3 screws from the system sink and lift it out.
- Page 5 29. Extract 1 screw from the 30. Lift the RJ45 connector and Bluetooth board and lift it out. cable out of the lower case. 31. Lift the external VGA connector 32. Press the stylus to release it and cover out of the lower case. slide it out.
- Page 6 37. Insert the RJ45 connector and 38. Insert the Bluetooth board and cable into the lower case. secure it with 1 screw. 39. Insert the RJ11 Connector and IO 40. Insert 2 hex screws into the Board and secure the board with 4 external VGA connector.
- Page 7 45. Connect the IO Board cable, the 46. Insert the WLAN card and secure Bluetooth cable, and the DC power it with 1 screw. cable to the system board. 47. Place the upper case and 48. Close the external VGA connect the ClickPoint button cable connector cover and secure the and the speaker cable.
- Page 8 53. Slide the lower hinge cover into 54. Turn the Display back and lay it place. down. 55. Plug in the cables for the 56. Turn the keyboard over and slide keyboard and ClickPoint. it into place 57. Press the keyboard upper trim 58.
- Page 9 61. Insert the Hard Drive. 62. Press the latch down to lock the cable into place. 63. Replace the Drive cover and 64. Replace the battery. secure it with 3 screws.