Siemens SINUMERIK 840D sl Programming Manual page 172
Measuring cycles
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Measuring variants
3.3 Measure workpiece (milling)
Parameter
Description
Protection
Use protection zone
zone
● Yes
● No
∅S
Diameter of the protection zone (only for protection zone "Yes")
XM, YM
The setpoint value specification for drill-hole center point (only for setpoint center point "Yes") mm
DX / DY / DZ
Infeed distance at measuring height (only for protection zone "Yes")
DFA
Measurement path
TSA
Safe area for the measurement result
Dimensional
Use dimensional tolerance for tool offset
tolerance
● Yes
● No
TUL
Workpiece upper tolerance limit (incremental to the setpoint, only for dimensional tolerance
"Yes")
TLL
Workpiece upper tolerance limit (incremental to the setpoint, only for dimensional tolerance
"Yes")
The "3D probe with spindle reversal" function is shown if bit 16 is set in the general SD 54760
1)
$SNS_MEA_FUNCTION_MASK_PIECE .
The "Align 3D probe" function is shown if bit 17 is set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
2)
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
3)
The contact angle always refers to the positive direction of the 1st axis of the active coordinate system, e.g. for G17 to +X,
4)
G18/+Z, G19/+Y
Measuring variant, turning on a milling machine (only 840D sl)
Procedure
Parameter
ShopTurn program
Parameter
T
D
172
Machine manufacturer
Please observe the information provided by the machine manufacturer.
1. Press the "Meas. workp." softkey.
2. Press the "Hole" softkey.
3. Press the "1 hole" softkey.
The input window "Measure: 1 hole" opens.
Description
Name of the probe
Cutting edge number (1 - 9)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
-
mm
mm
mm
mm
-
mm
mm
Unit
-
-
Measuring cycles
Hide quick links:
Advertisement
Table of Contents
