Table of Contents
Advertisement
Available languages
Available languages
Portable Mounting Using Clamps
— If necessary, clamp the miter saw to a workbench
or table top.
— Place two (2) or more "C" clamps on the clamping
areas and secure (Figure 15).
— Be careful not to place clamps over the base
extension clamping levers (Figure 15).
— Mounting with clamps will prevent access to some
wide miter angles.
Adjusting the Four Position
Setting Main Handle in Desired Position
The switch handle can be positioned in any of four
different orientations, depending on the cutting
situation and user preference.
G
vertical
G
horizontal
G
45° Left
G
45° Right
To reposition the main handle:
1. Release handle clamp (Figure 16).
2. Pull and hold handle rotation release lever
(Figure 16).
3. Rotate handle to desired location.
4. Let go over release lever to set handle into
place.
Release lever will retract down only in
one of the four (4) positions
Note:
Power switch can not be actuated unless
release lever is retracted down. Do not attempt to
switch tool on between handle position, damage may
occur.
5. Lock the handle clamp.
Adjusting the Four-Position Handle
Clamp Tension
1. Open handle clamp.
Mounting the Saw
Switch Handle
Clamping
Areas
Figure 15. Portable Mounting Using Clamps
2. Using 1.5 mm Allen wrench, increase tension by
turning both setscrews 1/4 turn to the left, tighten
by turning to the right. Always adjust both
setscrews by the same amount.
3. Close handle clamp.
4. Check the tension.
Handle
Clamp
Handle Rotation
Release Lever
Figure 16. Setting Main Handle Position
18.
Clamping Areas
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
