Advertisement
Quick Links
Package Contents
Dual Gang Wall Mount
(x4) #6-32 Machine Screws
Plastic Front Cover
(x2) T8H Torx Security Screw
205H-MNT2 Wall Mount Kit Installation Guide
Introduction
The 205H-MNT2 Wall Mount Kit provides a secure and practical solution for mounting the 205H access
point to single and dual gang wall boxes.
Installing the 205H-MNT2 Wall Mount Kit
Use the following instructions to install the 205H-MNT2 Wall Mount Kit.
1. If the wall box is not already exposed, unscrew and remove the existing wall plate, as shown in
Figure 1 Removing Existing Wall Plate
2. Detach any RJ-45 cables by unclipping the connectors from the wall plate, or cutting/removing the UTP
cable(s).
3. Use a short Ethernet cable (sold separately, part number AP-CBL-ETH10) to connect the E0 port to an
RJ-45 connector, or crimp an RJ-45 plug (not supplied) to the cable, and insert into the E0 port. Do the
same for the PT port if used.
0511763-03 |
March 2015
205H-MNT2 Wall Mount Kit
Installation Guide
Figure
1.
1
Advertisement
Related Manuals for HP 205H-MNT2
Summary of Contents for HP 205H-MNT2
- Page 1 205H-MNT2 Wall Mount Kit Installation Guide Introduction The 205H-MNT2 Wall Mount Kit provides a secure and practical solution for mounting the 205H access point to single and dual gang wall boxes. Installing the 205H-MNT2 Wall Mount Kit Use the following instructions to install the 205H-MNT2 Wall Mount Kit.
- Page 2 Installation for Single Gang Wall Box If mounting the 205H-MNT2 Wall Mount Kit to a single gang wall box, refer to steps 4-5. 4. Align the screw holes on the mounting bracket with the corresponding holes on the single gang wall box,...
- Page 3 205H access point into the mount. 12. Position the prongs on the back of the front cover inside the slots on the front mount housing, as shown Figure Figure 5 Fitting Front Cover onto Wall Mount 205H-MNT2 Wall Mount Kit | Installation Guide...
- Page 4 Screw into the hole located at the left side of the cover and tighten until secure. 15. (Optional) If not using PoE, connect the AC-DC power adapter (sold separately, part number AP-CBL- ) to the DC power socket located on the right of the 205H access point. 0511763-03 205H-MNT2 Wall Mount Kit | Installation Guide...