Table of Contents
Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
C
ommerCial
30" (76.2 CM), 36" (91.4 CM)
INSTRUCTIONS D'INSTALLATION
C
uiSinièreS à ConveCtion
De
RANGE SAFETY ..........................................................................2
INSTALLATION REQUIREMENTS ..............................................4
Tools & Parts .............................................................................4
Location Requirements .............................................................6
Water Filtration System Location Requirements ......................8
Water Supply Requirements .....................................................8
Electrical Requirements - U.S.A. Only ....................................9
Electrical Requirements - Canada Only ...............................10
Gas Supply Requirements ......................................................10
INSTALLATION INSTRUCTIONS ..............................................12
Unpack the Range ..................................................................12
Install Optional Backguard ......................................................13
Install Anti-Tip Bracket ............................................................13
Electrical Connection - U.S.A. Only ......................................14
Install Water Filtration System ................................................15
Make Gas Connection ............................................................17
Verify Anti-Tip Bracket Location .............................................17
Level Range .............................................................................18
Install Grill Grease Trays ..........................................................18
Install Griddle ..........................................................................19
Electronic Ignition System ......................................................19
Reinstall Kick Plate ..................................................................21
Complete Installation ..............................................................21
GAS CONVERSIONS .................................................................22
LP Gas Conversion .................................................................22
Natural Gas Conversion ..........................................................24
IMPORTANT:
Save for local electrical inspector's use.
Installer: Leave installation instructions with the homeowner.
Homeowner: Keep installation instructions for future reference.
IMPORTANT :
À conserver pour consultation par l'inspecteur local des installations électriques.
Installateur : Remettre les instructions d'installation au propriétaire.
Propriétaire : Conserver les instructions d'installation pour référence ultérieure.
W10825473B
-S
tyle
For residential use only
30" (76,2 Cm), 36" (91,4 Cm)
Pour utilisation résidentielle uniquement
Table of Contents/Table des matières
D
F
C
ual
uel
onveCtion
anD
-
Style CommerCial à bi
et
SÉCURITÉ DE LA CUISINIÈRE ................................................27
EXIGENCES D'INSTALLATION ................................................29
Outillage et pièces ...................................................................29
Exigences d'emplacement ......................................................31
Exigences d'emplacement du système
de filtration de l'eau .................................................................33
Spécifications de l'alimentation en eau ..................................33
Spécifications de l'installation électrique ...............................34
Spécifications de l'alimentation en gaz ..................................34
INSTRUCTIONS D'INSTALLATION ..........................................36
Déballage de la cuisinière .......................................................36
Installation du dosseret facultatif ............................................37
Installation de la bride antibasculement .................................37
Installation du système de filtration de l'eau ..........................38
Raccordement au gaz .............................................................39
Vérification de l'emplacement
de la bride antibasculement ....................................................40
Réglage de l'aplomb de la cuisinière ......................................40
Installation des plateaux à graisse du gril ...............................40
Installation de la plaque à frire ................................................41
Système d'allumage électronique...........................................42
Réinstallation du garde-pieds .................................................44
Achever l'installation ...............................................................44
CONVERSIONS POUR CHANGEMENT DE GAZ ...................45
Conversion pour l'alimentation au propane ...........................45
Conversion pour l'alimentation au gaz naturel .......................47
www.kitchenaid.com (U.S.A.) www.Kitchenaid.ca (Canada)
r
angeS
48" (121.9 CM)
-
CombuStible
48" (121,9 Cm)
Advertisement
Table of Contents
Related Manuals for KitchenAid KDRS467VBK00
Summary of Contents for KitchenAid KDRS467VBK00
-
Page 1: Table Of Contents
Homeowner: Keep installation instructions for future reference. IMPORTANT : À conserver pour consultation par l’inspecteur local des installations électriques. Installateur : Remettre les instructions d’installation au propriétaire. Propriétaire : Conserver les instructions d’installation pour référence ultérieure. W10825473B www.kitchenaid.com (U.S.A.) www.Kitchenaid.ca (Canada) -
Page 2: Range Safety
RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER”... - Page 3 In the State of Massachusetts, the following installation instructions apply: Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts. If using a ball valve, it shall be a T-handle type. A flexible gas connector, when used, must not exceed 3 feet.
-
Page 4: Installation Requirements
INSTALLATION REQUIREMENTS Tools & Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools Needed Z\, x 4 " flat-blade screw- Adjustable wrench #2 Phillips screwdriver Pipe wrench driver ⁄... - Page 5 Parts Supplied Parts Needed Power supply cord kit: ■ Check that all parts are included: 30" (76.2 cm) and 36" (91.4 cm) models – A UL listed ■ Anti-tip bracket kit 40-amp power supply cord kit ■ 48" (121.9 cm) models – A UL listed 50-amp power ■...
-
Page 6: Location Requirements
Location Requirements IMPORTANT: Observe all governing codes and ordinances. Product Dimensions Do not obstruct flow of combustion and ventilation air. It is the installer’s responsibility to comply with installation ■ 30" (76.2 cm) models clearances specified on the model/serial rating plate. The model/serial rating plate is located on the right vertical surface of the oven doorframe. - Page 7 48" (121.9 cm) models NOTE: The following illustration is for dimension planning purposes only, and the locations and appearances of the features shown may not match those of your model. O*** installation area Electrical installation area* A. Optional backguard may be installed. B.
-
Page 8: Water Filtration System Location Requirements
Water Filtration System Location Water Supply Requirements Requirements A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required to operate the steam (on some models) feature. In Massachusetts, plumbing code 248 CMR 3.00 and For best results, do not install the water filtration system 10.00 must be followed, and a licensed plumber will be used. -
Page 9: Electrical Requirements - U.s.a. Only
Electrical Requirements — U.S.A. Only If codes permit and a separate ground wire is used, it is If connecting to a 4-wire system: recommended that a qualified electrical installer determine This range is manufactured with the ground connected to the that the ground path and wire gauge are in accordance with cabinet. -
Page 10: Electrical Requirements - Canada Only
Gas Supply Requirements Electrical Requirements — Canada Only WARNING WARNING Explosion Hazard Electrical Shock Hazard Use a new CSA International approved gas supply line. Electrically ground range. Install a shut-off valve. Failure to do so can result in death, fire, or electrical shock. - Page 11 Gas Supply Line Gas Pressure Regulator The gas pressure regulator supplied with this range must be Provide a gas supply line of ¾" (1.9 cm) rigid pipe to ■ used. The inlet pressure to the regulator should be as follows the range location.
-
Page 12: Installation Instructions
INSTALLATION INSTRUCTIONS b. Lay kick plate to the side to avoid scratching Unpack the Range the stainless steel. c. Remove screws from range. WARNING Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. 1. -
Page 13: Install Optional Backguard
Measurement C: Install Optional Backguard Measurement C is the optional distance from the back wall. If back wall is constructed of a combustible material All ranges may require a backguard. See “Cabinet Dimensions” and a backguard is not installed, a 6" (15.2 cm) minimum in the “Location Requirements”... -
Page 14: Electrical Connection - U.s.a. Only
Electrical Connection — U.S.A. Only 30" (76.2 cm) and 36" (91.4 cm) Models 48" (121.9 cm) Models WARNING WARNING Electrical Shock Hazard Electrical Shock Hazard Disconnect power before servicing. Disconnect power before servicing. Use a new 40 amp power supply cord. Use a new 50 amp power supply cord. -
Page 15: Install Water Filtration System
4-wire connection: power supply cord 3-wire connection: power supply cord Use this method for: Use this method only if local codes permit connecting cabinet-ground conductor to neutral wire of power supply cord. New branch-circuit installations (1996 NEC) ■ 1. Use a ¼" nut driver to remove the hex washer head screws Mobile homes from the aluminum terminal blocks. - Page 16 If you need to release tubing: 3. Attach filter to the mounting ring. Push in collet to release tubing. With collet held in, pull tubing straight out. Mounting ring and screw A. Collet 1½" (3.8 cm) clearance Connect to Home Water Supply Connect to Water Filter Outlet (blue) 1.
-
Page 17: Make Gas Connection
5. Connect the flexible codes-approved water supply line 4. Use a ⁄ " combination wrench and an adjustable wrench to the range copper tubing, using a ¼" to ¼" water to attach the flexible gas supply to the adapters. Check that supply union. -
Page 18: Level Range
3. Lift burner assembly up and out to remove. Level Range 4. Slide drip tray into opening on the right front side of the grill basin. There are guides to assure correct placement of the NOTE: Range must be level for satisfactory baking drip tray. -
Page 19: Install Griddle
8. Insert front tabs of the flame spreader into slots at the front Electronic Ignition System of the grill basin, then the rear tabs into the rear slots. Install Burner Bases and Burner Caps Install the burner base, making sure the igniter electrode is properly aligned with the base. - Page 20 5. Pull up on the control console, and let it drop forward into Check Operation of Cooktop Burners the notched console brackets on each side. Push in and turn each control knob to LITE. NOTE: You will hear a clicking sound while the line clears. The surface burners and grill flames should light within 4 seconds.
-
Page 21: Reinstall Kick Plate
11. When finished adjusting the flame height, put a control Complete Installation knob back onto the valve stem and turn off the burner. 12. Remove the control knob. 1. Check that all parts are now installed. If there is an 13. -
Page 22: Gas Conversions
GAS CONVERSIONS IMPORTANT: Gas conversions from Natural Gas to LP Gas LP Gas Conversion must be done by a qualified installer. WARNING WARNING Explosion Hazard Use a new CSA International approved gas supply line. Tip Over Hazard Install a shut-off valve. A child or adult can tip the range and be killed. - Page 23 To Convert Gas Pressure Regulator To Convert Surface Burners 1. If the burner grates are installed, remove them. 1. Remove the access cap by using a wrench, turning the access cap counterclockwise. 2. Remove burner cap. 2. Remove spring retainer from the cap by pushing against 3.
-
Page 24: Natural Gas Conversion
To Convert Grill Burner (on some models) Complete Installation 1. Remove grill grate, wave plate, flame spreader, and burner 1. Refer to the “Make Gas Connection” section for properly assembly. See “Install Grill Grease Trays” section for connecting the range to the gas supply. removal instructions. - Page 25 To Convert Gas Pressure Regulator To Convert Surface Burners 1. Remove the access cap by using a wrench, turning 1. If the burner grates are installed, remove them. the access cap counterclockwise. 2. Remove burner cap. 2. Remove spring retainer from the cap by pushing against the 3.
- Page 26 Natural Gas Orifice Spud/Hood Chart 3. Turn Natural gas orifice hood down tightly onto orifice base. 4. Place LP gas orifice hoods in plastic parts bag for future Burner Rating Size Burner Style use and keep with package containing literature. 5.