To Replace The Hard Disk Drive Holder - HP OmniBook XE4400 User Manual
Technology code kd
Hide thumbs
Also See for OmniBook XE4400:
- Service manual (106 pages) ,
- Release note (4 pages) ,
- Startup manual (77 pages)
Table of Contents
Advertisement
To replace the hard disk drive holder
If you are installing a new hard drive that does not have a holder, you can remove the
holder parts from the old hard drive. You'll need a small Phillips screwdriver for this
procedure.
1. Remove the four screws from the sides of the holder and drive case, and then slide the
drive out of the holder.
2. Notice that the hard drive has a pin connector attachment at one end. Carefully
remove this connector from the end of the drive. Work alternately at each end so that
the connector slides off evenly without bending the connector pins.
3. Carefully put the pin connector attachment back onto the pins on the end of the new
hard drive. Work alternately at each end so that the connector slides on evenly
without bending the connector pins.
4. Insert the drive into the holder.
5. Reinstall the screws into the holder and drive case.
Add-On Devices
Replacing the Hard Disk Drive
Corporate Evaluator's Guide
93
Advertisement
Table of Contents
Troubleshooting
