Table of Contents
Advertisement
SC-P600
Panel Unit
Pane Cover Rear
Ferrite Core
Panel SUB Board
Remove the Panel
Cover Rear
Housing Panel Rear
C.B.P-TITE SCREW,3X8,F/ZN-3C (6 ± 1 kgf·cm)
When disassembling the Panel Unit, take off the fixed screws (x4)
of the shafts that of Housing Panel Rear. Then remove the unit
from the Housing Upper Support Assy by turning the whole unit
forward.
Waste Ink Tube / Waste Ink Pad
Installation
order
Waste Ink Tube
/ Tube Holder
Waste Ink Tube
Waste Ink Pads
C.B.P-TITE SCREW,3X8,F/ZN-3C (6 ± 1 kgf· cm)
When installing the Waste Ink Tube/Waste Ink Pads (x10),
confirm the shapes of them and install them in the order shown
above.
When installing the Waste Ink Tube, route it through the
groove of the Waste Ink Pads, and insert the end of the shorter
tube to the section A and longer one to the section B.
Disassembly/Reassembly
Rear side
Wireless LAN Module cable
When installing the Wireless LAN Module Assy, put the following four cables through a hook of the part right side.
•
Printer Cover Open Sensor cable
•
I/C Holder Unit Cover Open Sensor cable
•
Mist Board cable
•
ASF PE Sensor Cable
Decomp Pump Assy
Joint for Decomp Tube
Decomp Tube
1 mm or less
Left inside of Lower Housing
Section A
Section B
Lower Housing
Decomp Tube
When connecting the Decomp Tube to the joint of the I/C
Holder Unit, make sure the gap between the end of the Decomp
Tube to the base of the joint is 1 mm or less, and then secure
the tube with the hooks (x2).
Route the Decomp Tube through the groove of the Lower
Housing and secure the tube with the hook.
Detailed Disassembly/Reassembly Procedure for each Part/Unit
Wireless LAN Module Assy
Right side
·
C.B.P-TITE SCREW,3X10,F/ZN-3C (6±1 kgf
cm)
·
C.B.S-TITE SCREW,3X6,F/ZN-3C (6±1 kgf
cm)
APG Assy
Left side
1
I/C Holder Unit
2
Decomp Tube
C.B.S-TITE SCREW,3X6,F/ZN-3C(8 ± 1kgf· cm)
Hook
Groove
When installing the APG Assy, align the marks on the Spur
Gear,14.4 and PG Cam Left to match their phases as shown
above.
Tighten the screws in the order indicated in the figure above.
Longer spring leg
Hook
Black triangle mark
CR Scale
Attach the CR Scale to the spring leg with the black triangle
mark upward on the left side of the printer.
Attach the Torsion Spring, 0.39 as shown above.
Ink Tube
3
Spur Gear,14.4
PG Cam Left
Align triangle marks.
Acetate Tape
When installing the Ink Tube Holders (x2), install them on the
locations where the acetate tape (x2) is attached on the Ink Tube.
Revision D
CR Scale
Torsion Spring, 0.39
CR Scale
Ink Tube Holder
Ink Tube Holders
20
SE Group Confidential (Related Staff Only)
Hide quick links:
Advertisement
Table of Contents
