Table of Contents
Advertisement
Chapter 3
Communication Interface Module
Figure 3-3
Procedure: Replace the Communication Interface Module in the ONS 15252 MCU
Make sure the CIM is properly inserted into the ONS 15252 MCU guide rails.
Caution
Insert the CIM in Slot 17 directly below the NCB module (see
Step 1
Fit the module properly in the short guiding rail on the bottom.
Step 2
When the module is seated, use a slot or Phillips screwdriver to tighten the retaining screw.
Step 3
78-13767-01
CIM and NCB modules in an ONS 15252 MCU
LEGEND
CIM - Communication Interface Module
NCB Module - Network Controller Board module
Removing and Replacing a CIM
NCB Module
CIM
Figure
3-3).
Cisco ONS 15200 Module Handbook
3-5
Advertisement
Table of Contents
