Table of Contents
Advertisement
Technical Specifications
Figure 5-3
CLIP
Figure 5-4
CLIP
Located on lower right-hand corner of the NAM module are 4-bit configuration header (jumpers) that
the CLIP uses to identify the splitting ratio of the NAM. These jumpers display the split ratio in the web
interface and the CLI. The jumpers are numbered 1 through 4.
splitting ratio.
.
Table 5-2
Jumper
1 and 4
1
2
3
4
5.2 Technical Specifications
This section covers environmental and mechanical specifications for the NAM. Although the NAM is
an active device, optical and electrical specifications do not apply.
Cisco ONS 15200 Module Handbook
5-4
Protected NAM block diagram
MU
A
MU
--
MU
B
Unprotected NAM block diagram
MU
A
MU
--
NAM Jumper Settings
Splitting
Ratio
0/100
10/90
50/50
90/10
100/0
Labelled A
Coupler
Labelled according to coupling ratio
Labelled according to coupling ratio
Labelled B
Labelled A
Splitting
Labelled according to splitting ratio
Table 5-2
Chapter 5
Network Adaptation Module
MU Duplex A
MU Duplex B
MU Duplex A
lists the jumper setting for each
DWDM
DWDM
78-13767-01
Advertisement
Table of Contents
