Table of Contents
Advertisement
7.4.13
Exiting Full Address Mode
Figure 7.23 shows the procedure for exiting full address mode and initializing the pair of channels.
To set the channels up in another mode after exiting full address mode, follow the setup procedure
for the relevant mode.
Exiting full address mode
Halt the channel
Initialize DTCRB
Initialize DTCRA
Initialized and halted
Figure 7.23 Procedure for Exiting Full Address Mode (Example)
234
1.
Clear the DTE bit to 0 in DTCRA, or wait
for the transfer to end and the DTE bit
to be cleared to 0.
2.
Clear all DTCRB bits to 0.
3.
Clear all DTCRA bits to 0.
1
2
3
Advertisement
Table of Contents
