Complying With Speed-Torque Curve; Phase Synchronization During Supply System Switching; Space Requirements; Voltage And Frequency Fluctuations During Line Operation - Siemens SIMOTICS 1PQ8 Operating Instructions Manual
Low-voltage motor
Hide thumbs
Also See for SIMOTICS 1PQ8:
Table of Contents
Advertisement
Preparations for use
4.10 Complying with speed-torque curve
4.10
Complying with speed-torque curve
Exceeding the temperature class
If the speed-torque curve is not followed, the temperature class may be exceeded. An
explosion can occur. This can result in death, serious injury or material damage.
● Comply with the speed-torque curve.
● Observe the data on the extra rating plate on the motor.
4.11
Phase synchronization during supply system switching
NOTICE
Supply system switching
Damage to the machine may be caused when switching to another supply system with
different phasing.
● The phasing must be synchronized during switching. Use appropriate means to
4.12
Space requirements
Plan sufficient space on site for the machine so that the third-party fan can be disassembled
and assembled as required. The necessary space requirements are listed in the following
table:
Table 4-1
4.13
Voltage and frequency fluctuations during line operation
If nothing else is stamped on the nameplate, then the permissible voltage fluctuation is ±5 %
and the permissible frequency fluctuation is ±2 %, corresponding to range A in
IEC / EN 60034‑1. Permissible fluctuations that go beyond this are specified on the nameplate,
e.g. voltage fluctuation of ±10 % corresponding to range B in IEC / EN 60034‑1.
The following applies: Under practical operating conditions a machine may sometimes have
to be operated outside the limits of Range A. Exceptions of this sort should be limited with
regard to the values that arise, how often and for how long they occur. Where possible and
34
WARNING
synchronize the phasing.
Space required for removing/fitting the external fan
31.
345 mm
Shaft height
35.
345 mm
40.
360 mm
SIMOTICS TN Series N-compact 1PQ8
Operating Instructions 11/2018
45.
365 mm
Advertisement
Table of Contents
