Table of Contents
Advertisement
Installation
3
3.1. Appropriate
installation location
Contact an Authorized Service for the
installation of the product. In order to
prepare the product for use, refer the
information in the user manual and
ensure that electrical installation and
water installation are appropriate. If not,
call a qualified electrician and technician
to have any necessary arrangements
carried out.
WARNING:
B
not be held liable for damages that
may arise from procedures carried
out by unauthorized persons.
WARNING:
B
be plugged in during installation.
Otherwise, there is the risk of
death or serious injury!
WARNING:
of the room where the product
shall be place is so tight to prevent
A
passing of the product, remove
the door of the room and pass
the product through the door by
turning it to its side; if this does
not work, contact the authorized
service.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as hobs,
heater cores and stoves and at least 5
cm away from electrical ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Your product requires adequate air
circulation to function efficiently. If
the product will be placed in an alcove,
remember to leave at least 5 cm
clearance between the product and
the ceiling, rear wall and the side walls.
Manufacturer shall
Product must not
If the door clearance
10 /41 EN
• If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the side
walls. Check if the rear wall clearance
protection component is present at its
location (if provided with the product).
If the component is not available, or if
it is lost or fallen, position the product
so that at least 5 cm clearance shall be
left between the rear surface of the
product and the wall of the room. The
clearance at the rear is important for
efficient operation of the product.
• Do not install the product in places
where the temperature falls below
-5°C.
3.2. Installing the
plastic wedges
Plastic wedges supplied with the
product are used to create the distance
for the air circulation between the
product and the rear wall.
1. To install the wedges, remove the
screws on the product and use the
screws supplied together with the
wedges.
2. Insert the 2 plastic wedges onto the
rear ventilation cover as illustrated in
the figure.
Refrigerator / User Manual
Advertisement
Table of Contents
