Table of Contents
Advertisement
Quick Links
GB
ADG 673
ON button
OFF button
Delayed start button
Press the button repeatedly to delay the
start of the programme by 3, 6 or 9 hours.
Then press the Start button. The
dishwasher will start after the set time.
Detergent setting upon initial use and when using a different type of
detergent
1. Select the third programme in the relative table.
2. Press the START button for approx. 7 sec. to change the display.
3. Using the START button, select the desired detergent:
"3h" = 2in1, "6h" = 3in1, "9h" = other combined action detergents
(In this way the rinse aid and/or salt indicator is deactivated). All 3
LEDs light up = Powder detergent (factory setting).
4. Switch the appliance off and then switch it on again. The selected
detergent type will be indicated on the display for approx. 3
seconds. by the corresponding LEDs.
P
Programmes
1
Pre-Rinse
2
Quickwash
3
2)
Eco
4
Daily
5
Intensive
1)
Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to
different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness
and power supply voltage.
2)
Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on
the EN comparison test and other tests, contact the following address: "nk_customer@whirlpool.com".
Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1. OVERVIEW
Table 1.1.
Programme chart
Available
options
cold
Crockery to be washed later.
Lightly soiled crockery with no
40°C
dried-on food.
Normally soiled crockery.
50°C
Energy-saving programme with
prolonged drying cycle.
Normally to heavily soiled
60°C
crockery.
Recommended programme for
70°C
heavily soiled crockery, especially
suitable for pans and saucepans.
Programme selection button
Press the button repeatedly until the desired programme
indicator lights up.
START button
The indicator lights up during operation, flashes when a
fault occurs, and goes off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds; the selected
programme and options are cancelled. Main failure
displays (repeated flashing of the START indicator lamp)
can be cancelled by RESETTING. Detailed instructions
are given in chapter 5 "What to do, in the event of...".
Rinse aid level indicator and salt level indicator
They light up when rinse aid or salt need to be added.
Add just before starting a wash cycle.
Detergent
dispenser
Loading instructions
large small Litres kWh
—
X
X
X
X
1)
Consumption
Minutes
—
5,0
0,02
10
—
13,0
0,70
30+/-
X
16,0
1,05
195+/-
X
16,0
1,35
120+/-
X
17,0
1,65
145+/-
5019 396 01083
1)
1)
1)
1)
1
Advertisement
Table of Contents
Related Manuals for Whirlpool ADG 673
Summary of Contents for Whirlpool ADG 673
- Page 1 Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”. 5019 396 01083 Whirlpool is a registered trademark of Whirlpool USA...
- Page 2 2. QUICK REFERENCE GUIDE Detailed instructions are given in the following pages, see also chapter “5. What to do if...” 1. Switch on the Open the dishwasher door. appliance Press the ON button. Press the button to bring up the desired programme on the display. 2.
-
Page 3: How To Use The Appliance
3. HOW TO USE THE APPLIANCE PROGRAMME SELECTION Press the button to bring up the desired programme on the display. The appliance must be switched on. If required, select options (if supplied). The corresponding indicator lamp switches on. Appropriate programmes and relative available options are detailed in table 1.1 on page 1. Programme times stated in the table were obtained under normal conditions and may vary depending on conditions. - Page 4 3. HOW TO USE THE APPLIANCE c. How to adjust the rinse aid dosage regulator The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). Press the lever 2 to open the cover.
-
Page 5: How To Load The Racks
3. HOW TO USE THE APPLIANCE HOW TO LOAD THE RACKS UPPER RACK - depending on the model Multifunction support A three possible positions for long utensils, cups and glasses. Crockery holder B in horizontal position: cups/long utensils, in raised position for plates and stemware. -
Page 6: Precautions And General Recommendations
4. PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packing The packaging materials are 100% recyclable and marked with the recycling symbol. 2. Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. - Page 7 5. WHAT TO DO IF... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance...
- Page 8 5. WHAT TO DO IF... Crockery and cutlery ... Possible causes/solutions ...are not perfectly clean/have food In the event of frequent use of the Eco programme 50°C residues (if available), from time to time select the intensive 70°C programme (if available). The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see the instructions in “Maintenance and installation”).