Fitting New Door Glass; Fitting A New Door Seal; Adjusting Door Latch - Nectre Fireplaces MK3 Operating Instructions Manual
Hide thumbs
Also See for MK3:
- Installation instructions manual (6 pages) ,
- Operating instructions manual (10 pages)
Table of Contents
Advertisement
8
3.
FITTING NEW DOOR GLASS
This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
To replace the door glass:
1.
Two stainless steel strips hold the glass in place.
Remove the four screws from the stainless steel
strips with a 3mm hex key.
2.
Take out the glass, and check if the grey rope
beneath needs replacing. If so, replace this rope
as well.
FIBREGLASS ROPE
3.
Position the new glass on top of the grey rope and
re-fit the stainless steel strips and screws.
4.
Take extra care not to over-tighten the screws,
otherwise the glass will crack when the heater gets
hot and the door expands.
5.
Dispose of the old glass in a responsible manner.
4.
FITTING A NEW DOOR SEAL
This task may be easier with the door removed from the
appliance and laid horizontally on a work-bench.
1.
Remove any old seal from the door.
2.
Clean out the groove in the door that held the seal
using a flat-end screw driver or equivalent.
3.
Run a thin bead of clear roof and gutter silicone
along the groove.
4.
Starting at one end, press the new door seal rope
into the groove on the door.
5.
Refit the door if it has been removed and close.
APPLY SILICONE
5.
ADJUSTING DOOR LATCH
If the door does not close firmly, the latch can be adjusted.
The latch is fastened onto the door with two removeable
washers. Use a socket wrench to undo the M12 nut, then
remove one of the washers directly beneath the nut.
Securely fasten latch assembly again.
Close the door with the door handle to test for any
improvement. If no improvement, remove second washer.
Advertisement
Table of Contents
