Advertisement
FAN&THERMAL MODULE (with MAIN BOARD) & ANTENNA
Disassembly Notice
Please be sure to pull out adapter and disconnect the battery.
Step 1 : Disconnect EDP CABLE, BACKLIGHT FPC and KEYBOARD FFC.
Step 2 : Disconnect FAN CABLE and IO FFC.
Step 3 : Remove screw *12pcs on the MAIN BOARD and FAN.
Step 4 : Remove MB with Thermal MODULE, THERMAL DUCT and FAN .
Step 5 : Tear off the FOIL and remove the AUX ANTENNA and MAIN ANTENNA.
1
2
Disconnect
EDP CABLE
IO FFC
BACKLIGHT FPC
FAN CABLE
KEYBOARD FFC
3
Remove
Disconnect
4
Remove
5
Tear off and then Remove
Assembly Notice
Screws
QTY
2
SCREW M2.5*5L (K) B-ZN NY #1
6
SCREW M2*3.5L (4.5,0.8) (K) B-ZN
1
SCREW IMS 2.5X4 NI+NY
3
SCREW M2*2L (5,0.8) (K) #1
Assembly Notice
1. If FFC is damage during disassembly, please replace new one.
Here are some samples of FFC damage:
AUX
MAIN
2
.
For Antenna assembly,
please follow the below picture to
paste the FOIL and tidy cables.
Please use the
correct technique
to take fans off to
avoid getting out
of shape.
Spec
Torque (kgf-cm)
2.5 ± 0.2
2.0 ± 0.2
2.5 ± 0.2
2.0 ± 0.2
THERMAL DUCT
.
3
ECN change: Please paste THE DUCT
MYLAR L as below location:
FAN
20
Back
Advertisement
