Table of Contents
Advertisement
Water Filter
By-pass Cover
To fit the water filter follow the instructions below
referring to figures supplied:
1. Take out the upper salad crisper in the fridge as
shown in the figure below.
2. Unscrew the water filter by-pass cover.
Caution: Make sure that the Ice off mode is active
before taking out the by-pass cover.
Note: It is normal that a few drops of water drip
after the cover has been taken out.
3. After removing the red cover on the head of the
water filter, install it as shown in the figure below.
4. Press Ice Off button on the display again to exit
from this mode.
Water filter should be replaced every 6 months.
1
Bypass Cover
Water filter replacement warning will appear on
the screen after about 6 months. The warning light
will remain on for about 15 days before it starts
to flash. Once the filter has been replaced, this
warning light can be cancelled by pressing the
Eco Extra button on the display for 5 seconds.
The water filter must be removed as shown in the
figure when it is going to be replaced or when it
will no longer be used. Make sure that the Ice off
mode is active before removing the water filter.
If you do not want to use the water filter, warning
light should be cancelled. To do this, "Freezer
Set" and "Water/Ice Type Selection" buttons
must be pressed simultaneously for 2 seconds.
Filter warning will flash for 5 times when pressed
in this way and the warning will be cancelled.
Filter warning will flash for 10 times when the
same buttons are pressed for 2 seconds and the
warning will be reactivated.
2
EN
12
Water Pipe
Water Pipe
REMOVE
3
Filter
LOCK
Hide quick links:
Advertisement
Table of Contents
