Table of Contents
Advertisement
Available languages
Available languages
4. Timer
■
Timer functions are different by each remote controller.
■
Refer to the operation manual that comes with each remote controller for the details included an operation method.
5. Emergency Operation for IR Wireless Remote Controller
HEAT
6. Care and Cleaning
► Cleaning the filters
• Clean the filters using a vacuum cleaner. If you do not have a vacuum
cleaner, tap the filters against a solid object to knock off dirt and dust.
• If the filters are especially dirty, wash them in lukewarm water. Take care
to rinse off any detergent thoroughly and allow the filters to dry completely
before putting them back into the unit.
Caution:
• Do not dry the filters in direct sunlight or by using a heat source,
such as an electric heater: this may warp them.
• Do not wash the filters in hot water (above 122 °F [50 °C]), as this
may warp them.
• Make sure that the air filters are always installed. Operating the
unit without air filters can cause malfunction.
Caution:
• Before you start cleaning, stop operation and turn OFF the power
supply.
• Indoor units are equipped with filters to remove the dust of
sucked-in air. Clean the filters using the methods shown in the
following sketches.
ON/OFF
1
2
COOL
1 ON/OFF lamp (lit when unit is operating; unlit when unit is not operating)
2 Emergency operation
In cases where the remote control unit does not operate properly, use
either the
COOL or
HEAT button on the wireless remote control
signal receiver to toggle the unit on or off. On cooler only units, pushing
the
HEAT button toggles the fan on and off.
Pressing the
COOL or
Operation mode
Preset temperature
24 °C/75 °F
Fan speed
► Filter removal
Caution:
• In removing the filter, precautions must be taken to protect your
eyes from dust. Also, if you have to climb up on a stool to do the
job, be careful not to fall.
• When the filter is removed, do not touch the metallic parts inside
the indoor unit, otherwise injury may result.
■
PEAD-A·AA9
B
D
• While lifting the filter knob, pull it.
A Air intake
B Air outlet
HEAT button selects the following settings.
COOL
HEAT
24 °C/75 °F
High
High
A
C
D
C Filter
D Knob
9
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Chapters
Table of Contents
