Safety Instructions; To Reduce The Risk Of Fire, Electric Shock, Or Injury To Persons, Observe The Following - Thermador HMCB36FS Installation Manual
Installation instructions
Hide thumbs
Also See for HMCB36FS:
- Use & care manual (32 pages) ,
- Manual (31 pages) ,
- Design manual (62 pages)
Table of Contents
Advertisement
Available languages
Available languages
Read All Instructions Before Using the Appliance.
WARNING
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE
FOLLOWING:
A. Installation work and electrical wiring
must be done by qualified person(s) in
accordance with all applicable codes
and standards, including fire-related
construction.
B. Sufficient air is needed for proper
combustion and exhausting of gases
through the flue (chimney) of fuel
burning equipment to prevent back-
drafting. Follow the heating equip-
ment manufacturer's guideline and
safety standards such as those
published by the National Fire
Protection Association (NFPA), and
the American Society for Heating,
Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local
code authorities.
C. When cutting or drilling into wall or
ceiling, do not damage electrical
wiring and other hidden utilities.
D. Ducted fans must always be vented
to the outdoors.
E. Always unplug or disconnect the
appliance from the power supply
before servicing.
F. This unit is designed for indoor use
only. Use this unit only in the manner
intended by the manufacturer.
Parts Needed
Tape Measure
Phillips Head Screwdriver
Duct Tape
Ductwork (configuration varies
depending on location; see "Prior to
installation").
Additional Sheetmetal screws
(as necessary for ductwork installation)
SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
WARNING
For general ventilating use only. Do not
use to exhaust hazardous or explosive
materials and vapors.
To reduce risk of fire and to properly
exhaust air, be sure to duct air outside.
Do not vent exhaust air into spaces
within walls, ceilings, attics, crawl spaces
or garages.
TO REDUCE THE RISK OF FIRE, USE
ONLY METAL DUCT WORK.
To reduce the risk of fire or electric
shock, do not use the fan with any solid-
state speed control device.
This appliance has been found to be in
compliance with UL 507 Standard for
Electric Fans and CAN/CSA-22.2 No.
113 Canadian Standard for Fans and
Ventilators. It is the responsibility of the
owner and the installer to determine if
additional requirements or standard
apply in specific installation.
Parts Supplied
Appliance assembly (1)
Sheetmetal Screws (6)
Wood Screws (4)
Counter Sink Screws (2)
Hardware for brackets on vent (2)
Plugs UX6 (6)
3
Advertisement
Table of Contents
