IBM LS42 - BladeCenter - 7902 Service Manual page 75
Problem determination and service guide
Hide thumbs
Also See for LS42 - BladeCenter - 7902:
- Installation and user manual (90 pages) ,
- Installation manual (56 pages)
Table of Contents
Advertisement
Note: You might have to remove component fillers or covers before you can
install some components (see the Installation and User's Guide for more
information).
v Microprocessors and heat sinks. See "Installing a microprocessor and heat
sink" on page 59.
v DIMMs. See "Installing a memory module" on page 38.
v Hard disk drives. See "Installing a SAS drive" on page 36.
v Concurrent KVM card. See "Installing a concurrent KVM feature card" on
page 51.
v I/O-expansion cards. See "Installing an I/O expansion card" on page 43.
v (LS22 Type 7901 and single-width LS42 Type 7902 only) LS22 optimizer. See
"Installing the LS22 optimizer" on page 50.
2. Install the bezel assembly (see "Installing the bezel assembly" on page 34).
3. Install the MPE unit or expansion unit, if you removed one while you removed
the system board (see "Installing an expansion unit" on page 32).
4. Install the blade server cover (see "Installing the blade server cover" on page
30).
5. Install the blade server into the BladeCenter unit (see "Installing the blade
server in a BladeCenter unit" on page 28).
Chapter 4. Removing and replacing blade server components
63
Advertisement
Table of Contents
